User manual INDESIT IG 80 GY

[. . . ] The appliance has been designed for use in the ducting version (air exhaust to the outside ­ Fig. I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels L) There is a risk of fire if cleaning is not carried out in accordance with the instructions This appliance conforms to the European Directive EC/ 2002/96, Waste Electrical and Electronic Equipment (WEEE). By making sure that this appliance is disposed of in a suitable manner, the user is helping to prevent potential damage to the environment or to public health. [. . . ] Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. We recommend the use of an air exhaust tube which If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. Installation The following instruction should be followed to carry out the correct installation of the cooker hood. Fixing the hood to the lower part of the wall cabinet This type of appliance must be fitted inside a cabinet or inside another type of support structure. The overall measurements of the cooker hood are given in figure 2. Before proceeding with cooker hood installation, remove grille D by pressing the two side buttons A, as shown in figure 3. Fix the appliance in place using 4 screws B (not supplied) which are suited to the type of cabinet. After fixing the cooker hood to the lower part of the cabinet, place grille D (fig. During this procedure, make sure that grille D is fastened properly. Extraction through an outside wall The appliance expels the fumes through an outside wall or a duct. It is necessary to buy a telescopic pipe in accordance with the standards in use (inflammable) and connect it to flange H (Fig 1A). Recirculation To transform an extractor hood version into a filter hood version, contact your appliance dealer and ask for active charcoal filters. The filters should be fitted to the extraction assembly inside the hood, by centring them and rotating them 90 degrees, until they click into place (fig. To perform this operation, first remove grille D (fig. [. . . ] Extended use of the light reduces the average duration of the bulb. Replacing the acrylic or metal panels To replace the acrylic or metal panels, first remove grille D by pressing the two side buttons A, as shown in figure 3. 6) slider the key symbols are explained below: A = Light switch A1 = Off key A2 = On key B = Gemma warning light key C = Speed control We also recommend that the appliance is left running for 15 minutes after the food is cooked, in order to thoroughly eliminate all contaminated air. [. . . ]