User manual INDESIT PI950ASIX

[. . . ] Therefore, rooms containing LPG cylinders must be equipped with vents to allow gas to escape from the Enlarging the ventilation slot bottom in the event of a leak. Consequently, LPG cylinders, whether partially or completely full, must not be installed or stored in rooms or storage areas which are below ground level (cellars, etc. Only the cylinder currently being used should be kept in the room. It must not be exposed to direct heat sources (ovens, fireplaces, stoves, etc. [. . . ] The yellowgreen earth wire must be 2-3 cm longer than the other wires. Connecting the electricity supply cable to the mains Mount a normalised plug corresponding to the load indicated on the data plate. When connecting the appliance directly to the Gas connections The appliance must be connected to the main gas supply or to a gas cylinder in compliance with current national regulations. Before carrying out the connection, make sure the hob is compatible with the gas supply you wish to use. If this is not the case, follow the instructions indicated in the paragraph “Adapting to different types of gas. ” When using liquid gas from a cylinder, install a pressure regulator that complies with current national regulations. 13 GB  Check that the pressure of the gas supply is consistent with the values indicated in Table 1 (“Burner and nozzle specifications”). This will ensure the safe operation and longevity of your appliance while maintaining efficient energy consumption. Connection with a rigid hose (copper or steel)  Connection to the gas system must be carried out in such a way as not to place strain of any kind on the appliance. An adjustable L-shaped pipe fitting is found on the appliance supply ramp; it is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (the seal is provided with the appliance). • Control knobs for GAS BURNERS and ELECTRIC HOTPLATES* adjust the power or the size of the flame. GAS BURNER spark plug* enables a specific burner to be lit automatically. • SAFETY DEVICE* stops the gas flow if the flame accidentally dies out. 16 Start-up and use  The position of the corresponding gas burner or electric hotplate* is shown on every knob. Gas burners Each burner can be adjusted to one of the following settings using the relative control knob: • Off Maximum Minimum To light one of the burners, hold a lighted match or lighter close to the burner while pressing down and turning the corresponding knob anti-clockwise to the maximum power setting. In those models fitted with a safety device, the knob should be pressed for approximately 6 seconds so the automatic device keeping the flame alight can heat up. When using models equipped with spark plugs, light the desired burner by first pressing the gas burners button (marked by the symbol XXX), then pressing down the corresponding knob while turning it anti-clockwise towards the maximum power setting.  If the flame accidentally dies out, turn off the control knob and wait at least 1 minute before trying to relight it. To switch off the burner, turn the knob in a clockwise direction until it stops (position marked by the “•” symbol). Electric hotplates* The corresponding knob may be turned clockwise or anti-clockwise and set to six different positions: Setting Normal or Fast Plate 0 1 2-5 6 Off 4 Suggestions for using burners For maximum burner efficiency • Use appropriate cookware for each burner (see table below) so that the flames do not extend beyond the bottom of the cookware. • Always use cookware with a flat base and a cover. [. . . ] • Cleaning the hob with a damp sponge and drying with kitchen paper is sufficient for ordinary cleaning purposes. • The removable parts of the burner should be washed regularly with warm water and soap, ensuring any stubborn residue is removed. • For hobs that light automatically, clean the terminal part of the instant electronic ignition device thoroughly and regularly and check that the gas outlet holes are not clogged. • Electric hotplates should be cleaned with a damp cloth and lubricated with a little oil while still warm. [. . . ]