User manual INDESIT VIA 640.1 C

[. . . ] HOB Contents Important safety instructions 5 Safeguarding the environment 6 Declaration of conformity 6 Before use 6 Existing pots and pans 6 Recommended pot bottom widths 6 Power level table 7 Installation 7 Electrical connection 8 Instructions for use 9 Cleaning 11 Troubleshooting guide 11 Noises made by the hob 11 After-sales service 12 These instructions shall also be available on website: www. This manual and the appliance itself provide important safety messages, to be read and always observed. This is the danger symbol, regarding safety, warning of potential risks to users and others. All safety messages will be preceded by the danger symbol and the following words: DANGER Indicates a hazardous situation which, if not avoided, will result in serious injury. [. . . ] - Disconnect the appliance from the power supply. - Installation must be carried out by qualified personnel who know the current safety and - The manufacturerdeclines all liability for injury to persons or animals andfordamage to property resulting fromfailure to observe the regulations - The power cable must be long enough to allow the hob to be removed from the worktop. - Make sure the voltage specifiedon the dataplate locatedon the bottomof the appliance is the same as that of the home. Remove the terminal cover (A) by unscrewing the screw and insert the cover into the hinge (B) of the terminal. Plug the power cord into the clamp and connect the wires to the terminal block as shown in the wiring diagram located near the terminal. Secure the power cable with the cable clamp. Close the cover (C) and screw on the terminal with the screw removed. For each connection to the network, the hob automatically checks for a few seconds. To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch off. If the hob has been in use, the residual heat indicator "H" remains lit until the cooking zones have cooled down. If within 10 seconds of switching on, no function is selected, the hob switches off automatically. Place the pot on the cooking zone, switching the hob on, activate the required cooking zone by pressing the corresponding "+" button "0" appears on the display. It is possible to select the required power level, from min. To increase the power level, push the "+" button. To decrease the power level push the "-" button. Deactivation of cooking zones To switch off the cooking zone, press the corresponding "+" and "-" button for more than 3 seconds. The cooking zone switches off and, if still hot, the letter "H" appears on the zone display. Control panel lock This function locks the controls to prevent accidental activation of the hob. To activate the control panel lock, switch the hob on and press the Lock function button for three seconds; an acoustic signal and a luminous indicator near the padlock symbol signal activation. The control panel is locked except for the switching off function. [. . . ] Switch the appliance off and then on again it to see if the problem has been eliminated. If the problem persists after the above checks, contact the nearest After-Sales Service. The product type and exact model; · The Service number (the number after the word Service on the rating plate), located under the appliance (on the metal plate). If any repairs are required, contact an authorised After-Sales Service Centre (to ensure the use of original spare parts and correct repairs). [. . . ]