User manual INDESIT VID 641 B C

[. . . ] HOB Contents Important safety instructions 5 Safeguarding the environment 6 Declaration of conformity 6 Before use 6 Existing pots and pans 6 Recommended pot bottom widths 6 Power level table 7 Installation 7 Electrical connection 8 Instructions for use 9 Cleaning 11 Troubleshooting guide 11 Noises made by the hob 11 After-sales service 12 These instructions shall also be available on website: www. This manual and the appliance itself provide important safety messages, to be read and always observed. This is the danger symbol, regarding safety, warning of potential risks to users and others. All safety messages will be preceded by the danger symbol and the following words: DANGER Indicates a hazardous situation which, if not avoided, will result in serious injury. [. . . ] Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them. To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance. - Disconnect the appliance from the power supply. - Installation must be carried out by qualified personnel who know the current safety and - The manufacturerdeclines all liability for injury to persons or animals andfordamage to property resulting fromfailure to observe the regulations - The power cable must be long enough to allow the hob to be removed from the worktop. - Make sure the voltage specifiedon the dataplate locatedon the bottomof the appliance is the same as that of the home. Remove the terminal cover (A) by unscrewing the screw and insert the cover into the hinge (B) of the terminal. Plug the power cord into the clamp and connect the wires to the terminal block as shown in the wiring diagram located near the terminal. Secure the power cable with the cable clamp. Close the cover (C) and screw on the terminal with the screw removed. For each connection to the network, the hob automatically checks for a few seconds. Power management step 1 Power management step 1 Power management step 1 Power management step 1 Switching the hob ON/OFF To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch off. If the hob has been in use, the residual heat indicator "H" remains lit until the cooking zones have cooled down. If within 10 seconds of switching on, no function is selected, the hob switches off automatically. Place the pot on the cooking zone, switching the hob on, activate the required cooking zone by pressing the corresponding "+" button "0" appears on the display. It is possible to select the required power level, from min. To increase the power level, push the "+" button. To decrease the power level push the "-" button. Deactivation of cooking zones To switch off the cooking zone, press the corresponding "+" and "-" button for more than 3 seconds. The cooking zone switches off and, if still hot, the letter "H" appears on the zone display. Control panel lock This function locks the controls to prevent accidental activation of the hob. [. . . ] Increase / decrease the cooking zones activated, the background noise of the fan may increase or decrease. These conditions are normal and essential for the proper functioning of the induction system, they are not indication of failure or damage. Before contacting the After-sales Service: 1. See if you can solve the problem yourself with the help of the "Troubleshooting guide". [. . . ]