User manual INDESIT VRA 631 T X

[. . . ] 31 USING THE HOB. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 CLEANING AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 POSITIONING ON THE HOB TOP. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 ELECTRICAL CONNECTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Illicit disposal of the product by the user will lead to the application of administrative sanctions. The product does not contain substances in quantities sufficient to be considered hazardous to health and the environment, in accordance with current European directives. 3. 2 Your environmental responsibility Our products packing is made of non-polluting materials, which are therefore compatible with the environment and recyclable. Please help by disposing of the packaging correctly. You can obtain the addresses of collection, recycling and disposal centres fromyour retailer or from the competent local organisations. Do not discard the packaging or any part of it, or leave it unattended. It can constitute a suffocation hazard for children, especially the plastic bags. Your old appliance also needs to be disposed of correctly. Important: hand over your appliance to the local agency authorised for the collection of electrical appliances no longer in use. Correct disposal enables intelligent recovery of valuable materials. Before disposing of your appliance it is important to remove doors and leave shelves in the same position as for use, to ensure that children cannot accidentally become trapped inside during play. It is also necessary to cut the connecting cable to the power grid, removing it along with the plug. 30 Instructions for the user 4. Use ordinary non-abrasive products for steel, with the aid of wooden or plastic utensils if necessary. On everyday dirt, limestone stains and rings it is advisable to use stainless steel cream with a microfibre cloth; on resistant charred dirt use oven cleaner with a microfibre cloth. Rinse thoroughly and dry with a soft or microfibre cloth. 35 Instructions for the user 6. 2 Cleaning parts 6. 2. 1 Knobs The knobs should be cleaned with a soft cloth dampened with warm water, then dried carefully. For ease of cleaning they can be extracted by pulling upwards. Do not use aggressive products containing alcohol or products for cleaning steel and glass when cleaning the knobs, as these products could cause permanent damage. 6. 2. 2 Racks For everyday dirt use a damp microfibre cloth; for incrustations leave to soak with washing-up liquid and boiling water, then rub with with a Scotch bright sponge or with a brass brush, rinse and dry with a microfibre cloth and put it back on the hob. 6. 2. 3 Flame-spreader crowns The flame-spreader crowns can be removed. Wash them with warm water and non-abrasive detergent, making sure to remove any encrustations. To remove charred resistant dirt use oven cleaner with a Scotch bright sponge. For less stubborn dirt and for polish use stainless steel cream with a microfibre cloth. Reposition them ensuring that they are completely dry and insert them correctly in their housings (see Chapter "5. [. . . ] Installation with the flexible hose must be carried out so that the length of the piping does not exceed 2 metres when fully extended; make sure that the hoses do not come into contact with moving parts and that they are not crushed in any way. 40 Instructions for the installer 9. 1 Connection to liquid gas Use a pressure regulator and make the connection on the gas cylinder following the guidelines set out in the regulations in force. Make sure that the supply pressure complies with the values indicated in the paragraph "3. 2 Burner and nozzle characteristics table". 9. 2 Ventilation in the room containing the appliance The room containing the appliance should have a permanent air supply in accordance with the standards in force. The room where the appliance is installed must have enough air flow needed for the regular combustion of gas and the necessary air change in the room itself. [. . . ]