User manual INDESIT WD 84 T

[. . . ] That the inlet and draining pipes are connected correctly. Never use pipes that have already been used. That the washer-dryer is levelled properly; something worth checking to aid the performance of your washer-dryer; 4. That the drum's fixing screws have been removed from the back of the washer-dryer; 2. [. . . ] Detergents that are specifically formulated for both hand and machine wash are an exception. One last secret: when washing with cold water, always reduce the amount of detergent you use: it dissolves less easily in cold water than in hot water, so part of it would be wasted. In compartment 1: Detergent for pre-washing (powder) In compartment 2: Detergent for washing (powder or liquid) 1 2 3 In compartment 3: Additives (softeners, perfumes, etc. ) The detergent dispenser can be removed and cleaned: pull it outwards, as indicated in the figure. Then leave it under running water for a few minutes. Cutting costs efficiently A guide to environmentally friendly and economic use of your appliance. MAXIMISE THE LOAD SIZE Achieve the best use of energy, water, detergent and time by using the recommended maximum load size. SAVE up to 50% energy by washing a full load instead of 2 half loads. SAVE detergent, time, water and between 5 to 15% energy consumption by NOT selecting Prewash for slight to normally soiled laundry. Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wash programme. SAVE up to 50% energy by using a 60°C wash programme. SAVE energy and time by selecting the highest suitable spin speed to reduce the water content in laundry before using a drying programme. Instructions for installation and use 8 Troubleshooting Before calling, read the following In most cases, when your washer-dryer fails to work, the problems arising can be easily solved without having to call for a technician. Before calling for assistance, always check these points. The washer-dryer fails to start. Is the plug correctly inserted into the socket?It could have been moved whilst cleaning. The tract of the rubber hose bringing water to washerdryer must be as straight as possible. Make sure it is not squashed or kinked. The washer-dryer continuously fills and drains water. Is the drain hose positioned too low?It must be installed at a height ranging from 60 to 100 cm. Is the end of the hose immersed in water?Does the wall drainage system have a breather pipe?If the problem persists even after these checks, turn the water supply off the machine and call for assistance. If you live on an upper floor of your building, there may be a problem with your drain trap. To solve this problem, a special valve must be installed. The programme selector knob keeps turning? Wait a few minutes for the drain pump to empty the tub, switch the washer-dryer 9 Instructions for installation and use Is the drain hose kinked?The tract of the drain hose must be as straight as possible. Make sure the drain hose is not squashed or kinked. Is the washer-dryer's drain duct clogged? [. . . ] It must only be used by adults and exclusively for washing clothes following the instructions provided in this manual. Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. Never try to do this alone, because the appliance is very heavy. Before loading the washerdryer, make sure the drum is empty. [. . . ]