User manual INDESIT WD12S

[. . . ] The cable should be cut as close as possible to the moulded plug. WARNING: To avoid a shock hazard do not insert the discarded plug into a socket anywhere else. Positioning and connection Positioning 1. Place the appliance in a well-ventilated humidity-free room. The compressor and condenser give off heat and require good ventilation to operate correctly and save energy. [. . . ] Insert the plug into the socket and ensure that the internal light illuminates. Turn the TEMPERATURE ADJUSTMENT knob to an average value. After a few hours you will be able to put food in the refrigerator. Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). Remember that cooked foods do not last longer than raw foods. Do not store liquids in open containers. They will increase humidity in the refrigerator and cause condensation to form. Due to the special guides the shelves are removable and the height is adjustable (see diagram), allowing easy storage of large containers and food. Height can be adjusted without complete removal of the shelf. GB 1 2 Using the refrigerator to its full potential The temperature inside the refrigerator compartment automatically adjusts itself according to the position of the thermostat knob. 1 = warmest 5 = coldest We recommend, however, a medium position. The cooling section of the refrigerator is located inside the back wall of the refrigerator compartment for increased space and improved aesthetics. If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Defrosting the appliance !Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair. Defrosting the refrigerator compartment The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. It is necessary to clean the discharge hole regularly so that the water can flow out easily. 6. until the ideal storage conditions have been restored, before placing food in the freezer compartment. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W). 6 Precautions and tips !The appliance was designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. This appliance complies with the following Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; -89/336/EEC of 03. 05. 89 (Electromagnetic Compatibility) and subsequent amendments; - 2002/96/CE. . Disposal Observe local environmental standards when disposing packaging material for recycling purposes. [. . . ] Do not allow children to tamper with the controls or play with the appliance. Under no circumstance should they be allowed to sit on the bins or to hang from the door. Keep packaging material out of the reach of children!It can become a choking or suffocation hazard. Respecting and conserving the environment Install the appliance in a fresh and well-ventilated room. [. . . ]