User manual INDESIT WIA111

[. . . ] Check whether the washing machine has been damaged during transport. If this is the case, do not install it and contact your retailer. Remove the 3 protective screws and the rubber bush with the respective spacer, situated on the rear of the appliance (see also the installation leaflet). NB: The plastic spacers may fall down inside the machine once the bolt has been removed, and will not interfere with the operation of the machine. [. . . ] Pressing the button again restarts the programme from the point at which it was interrupted. PROGRAMME/ON-OFF knob: sets the desired programme (see page 8) and switches the machine on or off. The knob stays still during the cycle. 6 Leds The LEDS provide important information. This is what they can tell you: Cycle progress: During the wash cycle, the LEDs gradually illuminate on to indicate the cycle progress: Prewash/Wash Rinse Spin cycle Note: during draining, the LED corresponding to the Spin cycle phase will be turned on. Function buttons The FUNCTION BUTTONS also act like LEDS. When a function is selected, the corresponding button is illuminated. If the function selected is incompatible with the programme set, the button will flash and the function will not be enabled. If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled. GB Installation Description Programmes Detergents Precautions Care Troubleshooting Service DOOR LOCK led: If this LED is on, the appliance door is locked to prevent it from being opened accidentally; to avoid any damages, wait for the LED to flash before you open the appliance door.  The rapid flashing of the DOOR LOCK Led together with the flashing of at least one other LED indicates there is an abnormality (see page 13). 7 Starting and Programmes Briefly: starting a programme GB 1. Switch on the washing machine by turning the PROGRAMME/ON-OFF knob to the desired programme. All the LEDS will light up for a few seconds and the DOOR LOCK Led will begin to flash. Load your laundry into the washing machine and shut the appliance door. • This washing machine should only be used by adults and in accordance with the instructions provided in this manual. • Never touch the washing machine when barefoot or with wet or damp hands or feet. • Do not pull on the power supply cable to unplug the appliance from the electricity socket. • Do not open the detergent dispenser while the appliance is in operation. • Do not touch the drain water as it could reach very high temperatures. • Never force the washing machine door: this could damage the safety lock mechanism designed to prevent any accidental openings. • In the event of a malfunction, do not under any circumstances touch internal parts in order to attempt repairs. • Always keep children well away from the appliance while in operation. • The appliance door tends to get quite hot during the wash cycle. • Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. Never try to do this alone, because the appliance is very heavy. [. . . ] If you see any cracks, replace it immediately: during the wash cycles, water pressure is very strong and a cracked hose could easily split open.  Never use hoses that have already been used. 12 Troubleshooting Your washing machine could fail to work. Before calling for Assistance (see page 14), make sure the problem can't easily be solved by consulting the following list. GB Installation Problem The washing machine won't start. Possible causes/Solution: • • • • The appliance is not plugged into the socket, or not enough to make contact. The appliance door is not shut properly. The START/PAUSE button has not been pressed. [. . . ]