User manual INDESIT WIDL102

[. . . ] (1) Eco-hazardous substances test report should be submitted when Part certification test and First Mass Production. Please read this manual carefully before operating your set and retain it for future reference. Com A-2 TABLE OF CONTENTS TABLE OF CONTENTS A-3 Setting up the TV A-3 A-6 Attaching the stand Tidying cables COMMON language list English Italiano LANGUAGE B-1 MAKING CONNECTIONS B-1 B-2 B-2 B-3 B-4 B-5 B-6 B-6 B-7 B-7 B-8 B-9 B-10 B-11 Antenna connection Satellite dish connection HDMI connection - ARC (Audio Return Channel) DVI to HDMI connection Component connection Composite connection MHL connection Audio connection - Digital optical audio connection USB connection CI module connection Headphone connection Euro Scart connection B-13 SPECIFICATIONS COMMON SETTING UP THE TV A-3 Setting up the TV Image shown may differ from your TV. Attaching the stand LA62**, LA64**, LA66**, LN57**-ZE/ZK 1 4 EA M4 x 14 3 (Only LA62**, LN57**-ZE/ZK) Stand Body Front Stand Base M4 x 14 4 EA 2 (Only LA62**, LN57**-ZE/ZK) (Only LA64**, LA66**) (Only LA64**, LA66**) M4 x 14 4 EA A-4 SETTING UP THE TV LA69**, LA74** 3 1 Stand Base M4 x 20 4EA 2 SETTING UP THE TV A-5 LN57**-ZA 1 Stand Body 3EA P5 x 25 CAUTION yy When attaching the stand to the TV set, place the screen facing down on a cushioned table or flat surface to protect the screen from scratches. [. . . ] »» If there is a voltage difference between TV Set and GND of antenna signal, the antenna contact might be heated and excessive heat might cause an accident. -- You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. It is recommended to mount the isolator to the wall. If it cannot be mounted to the wall, mount it on the TV. Avoid disconnecting the antenna Isolator after installation. -- Before starting, be sure that the TV antenna is connected. Connect one end of the isolator to cable/antenna jack and the other to TV set or set-top box. €Equipment connected to the protective earthing of the building installation through the mains connection or through other equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some circumstances create a fire hazard. Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below a certain frequency range (galvanic isolator, see EN 60728-11)” W  hen applying the RF Isolator, a slight loss of signal sensitivity can occur. 16 ASSEMBLING AND PREPARING Separate purchase (Depending on model) Separate purchase items can be changed or modified for quality improvement without any notification. These devices only work with certain models. Using the Kensington security system (This feature is not available for all models. Yy The Kensington security system connector is located at the rear of the TV. For more information of installation and using, refer to the manual provided with the Kensington security system or visit http://www. Connect the Kensington security system cable between the TV and a table. 2 EA , P4 x 8 (Only 47/50LN57**-ZE/ZK , 47/50LA62** , 47/50L A64** , 47/50LA66**) 2 EA , M4 x 8 (Only 32/39/42LN57**-ZE/ZK , 32/39/42LA62** , 32/42LA64** , 32/42LA66**)  20 ASSEMBLING AND PREPARING NOTE (Only 32/39/42/47/50LN57**-ZE/ZK , 32/39/42/47/50LA62** , 32/42/47/50LA64** , 32/42/47/50LA66**) How to fix the TV to a table 1. Connect the Desk-mount Cables to the Stand Base using the Bracket Screws. Fix the Desk-mount Cables to a table using the Desk-mount Screws. Once the TV is fixed, move the table close to the wall. Adjusting the angle of the TV to suit view (This feature is not available for all models. ) Swivel 15 degrees to the left or right and adjust the angle of the TV to suit your view. (Only LA62**, LA64**, LA66**, LN57**-ZE/ZK) ENGLISH ENG 15 15 WARNING yy To prevent TV from falling over, the TV should be securely attached to the floor/ wall per installation instructions. [. . . ] Yy If the TV does not display any video and audio when CI+ CAM is connected, please contact to the Terrestrial/Cable/Satellite Service Operator. NOTA H/P OUT (*Not Provided) English Transmits the headphone signal from the TV to an external device. Connect the external device and the TV with the headphone as shown. When changing AV MODE with a headphone yy connected, the change is applied to video but not to audio. [. . . ]