User manual INDESIT WM

[. . . ] That the inlet and draining pipes are connected correctly. Never use pipes that have already been used; 3. That the washing machine is levelled properly; something worth checking to aid the performance of your washing machine; 4. That the drum's fixing screws have been removed from the back of the washing machine. 2. [. . . ] Even during maintenance, the appliance should always be unplugged. Never use solvents or abrasives to clean the external and rubber parts of the washing machine. It is removable and can easily be cleaned by leaving it under running water. Go on holiday without thinking about her. Before leaving, always make sure that the washing machine is unplugged and that the water supply is turned off. Is the hose correctly connected to the tap?There could be work in progress in your building or street. If the water is very calcareous, or if work has recently been carried out on the water piping, the tap filter could be clogged with particles and debris. The tract of the rubber hose bringing water to washing machine must be as straight as possible. Make sure it is not squashed or kinked. The washing machine continuously fills and drains water. Is the drain hose positioned too low?It must be installed at a height ranging from 60 to 100 cm. Is the end of the hose immersed in water?Turn off the water supply, unplug the appliance and try tightening its attachment. Always get assistance from authorised technicians and always insist on original spare parts. Technical characteristics Model Dimensions WM width 59, 5 cm height 82 cm depth 53, 7 cm from 1 to 5, 5 kg voltage 230/240 Volt 50 Hz maximum absorbed power 2050 W maximum pressure 1 MPa (10 bar) minimum pressure 0, 05 MPa (0, 5 bar) drum capacity 46 litre up to 1200 rpm Capacity Electrical connections Water connections Spinning speed Control programs in programme 3; temperature 60°C; carried out with 5 kg load. compliance with IEC regulation 456 This appliance conforms with the following E. E. C. directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications 9 Instructions for installation and use Installation and removal When the new washer arrives Whether new or just transported to a new house, installation is extremely important for the correct functioning of your washing machine. After removing the appliance from its packaging, check that it is intact. If in doubt, contact a qualified technician immediately. The inside of the machine is supported, for transportation, by four screws on the back panel. Connection to the water mains Both hot and cold water supplies are preferable and they should be between 34. 5kN/m²(5lb/in²) and 1034. 2kN/m² (150lb/in²) pressure. The hose having the red end fitting should be encountered between the hot supply and the threaded connection adjacent to the letter H on the rear of the machine. The hose having the white end fittings should be connected between the cold supply and the threaded connection adjacent to the letter C on the rear of the machine. Remember to insert a sealing washer at each connection to ensure watertight joints. Do not overtighten the connections by using tools -hand tight is sufficient to prevent leaks. It is generally more convenient to have these supplies away from the sink taps. [. . . ] The power supply cable must never be bent or dangerously compressed. I only want an authorised specialised technician with original Indesit spare parts! Your washer has been built in compliance with the strictest international safety regulations. Never pull on the supply cable or the washing machine to disconnect it from the wall socket: it is extremely dangerous. While the appliance is functioning, do not touch the drain water as it could reach very high temperatures. The appliance door, during wash cycles, tends to become hot; ensure that children do no touch it. [. . . ]