User manual INFOCUS TD40 DOCUMENT

[. . . ] Normal TV has a 4:3 aspect ratio, while the TD40 has a 15:9 aspect ratio for HDTV. Press the V. Size button on the remote control to change the aspect ratio. Each time you press the V. Size button, you go to the next setting. The picture resizes so that the image fits from top to bottom, leaving black areas on the right and left sides. [. . . ] A slider adjustment appears on the bottom of the screen. 3 4 Use the VOL+ and VOL­ buttons to adjust the setting. When you finish, press the Back button until the menus disappear. 2 No image or very poor image on a specific channel. 5 Make sure the channel is in the tuner memory. If it is not, tune in the channel with the remote control keypad, then press the CH ADD button. To fine tune a channel, press the Menu button on the remote control. Then navigate to TV Menu > Fine Tune. (See Remote Control FAQs for information about using the remote control. ) Adjust the internal tuner using the VOL+ and VOL­ keys until you get the best image. If the fine tuning is ineffective, this is probably a cable or antenna issue. If you have cable, contact your cable provider. If you have an antenna, try adjusting the antenna. 6 7 8 Jittery or shaky image 1 Confirm that the video signal is compatible with the TD40. The NTSC version is compatible only with NTSC standard video, and the PAL version is compatible only with PAL/SECAM video. If you play PAL or SECAM video through the NTSC version, the image is likely to be unstable, noisy, or may be in black and white. Check the image from a video player (DVD or other). If the video image does not shake, the issue probably lies with the cable or antenna. If video image is also jittery, the unit probably requires repair. The colors, brightness or contrast is not right. The TD40 includes four color modes, Standard, Vivid, Mild and User. Press the Picture button on the remote control to cycle through the four settings. The image changes as you select each mode. To customize any of the settings, see How do I change the color, contrast, and tint?How do I change the color, contrast, and tint? [. . . ] There are two ways to make the channels appear, through the Channel Add function and the Auto Scan function. If you want to add specific channels, use the number pad on the remote control to tune the channel in, then press the CH ADD button on the remote control. Do this for each channel you want to appear. (You can also delete any channel from the TD40 memory by tuning the channel and then pressing CH ERASE button). [. . . ]