User manual INFOSEC SMART LINE 500 VA

[. . . ] Disconnect Smart Line from AC power before cleaning it. Do not use product but only a damp cloth. In case of emergency, switch Smart Line into off position and disconnect the product from the AC power. When Smart Line is out of order, please refer to "trouble shooting" section and contact the hot line. [. . . ] 4) When replacing batteries, replace with the same type and number of the sealed lead-acid batteries. STORAGE INSTRUCTIONS Smart Line should be stored with its battery fully recharged. If Smart Line has to be stored for a long time, it is recommended to recharge the batteries (by connecting the utility power to UPS, switch "ON"), once a month for 24 hours to avoid a full battery discharge. Do not keep or use Smart Line in any of the following environments: Any area with combustible gas, corrosive substance or heavy dust. Any area with extraordinarily high or low temperature (above 40°C or below 0°C) and humidity of more than 90%. Any area exposed to direct sunshine or near any heating apparatus. In the event that there is fire occurring in the vicinity, please use dry-powder extinguishers. The use of liquid extinguishers may give rise to the danger of electric shock. When calling the After-Sales Department, please have the following information ready, it will be required anyway : product model, serial number and date of purchase. accurate description of the problem providing the following details : type of equipment powered by the Smart Line , indicator led status , alarm status , installation and environmental conditions. You will find the technical information you require on your guarantee or on the identification plate on the back of the unit. If convenient you may write down the details in the following box. Control When you receive your equipment, open the packaging and check that your Smart Line has not been damaged. Charging Smart Line is shipped from the factory with its internal battery fully charged, however, some charge may be lost during shipping and the battery should be recharged prior to use. Plug the unit into an appropriate power supply and allow the UPS to charge fully by leaving it plugged-in for at least 10 hours with no load (no electrical devices such as computers, monitors. Place and installation Smart Line has been designed to operate in a protected environment, at temperatures between 0° C and 40° C and at a rate of humidity ranging between 0 % and 90% (no condensation). do not obstruct the ventilation grills. Install the unit in any protected environment that provides adequate airflow around the unit, and is free from excessive dust, corrosive fumes and conductive contaminants. [. . . ] BATTERY The battery is the only UPS component which is not in permanent use. it has a product life of approximately 3 to 5 years. However, frequent major discharges or exposure to temperatures over 20°C will shorten its product life. We therefore recommend that users recharge the battery once a month when the unit is not in use in order to compensate for natural discharging. [. . . ]