User manual INNOTEK ULTRASMART

[. . . ] INNOTEK® UltraSmartTM Micro Remote Trainer IUT-300, IUT-302 About your INNOTEK® UltraSmartTM Remote Trainer Now you can experience the difference a remote trainer can make. INNOTEK® training products have just the right touch, right when you need it. INNOTEK® products are the quicker way to a better-behaved dog. The display shows at a glance which level your remote is set on. You can even train 2 dogs at once ­ the display shows or indicate which dog you are controlling. D dto This handheld remote is small yet full-featured. [. . . ] See table strengthen a dog's response to training. Tones can be used on page 6. as a warning tone prior to pressing the stimulation 4 Charging the Collar The collar charging station has been designed to plug into a standard 110v wall outlet and act as a charging stand for your collar. Position the collar in the charging cradle. The collar fits in the cradle with the contacts facing down through the holes in the case. A built-in safety circuit prevents the unit from overcharging. The collar's light glows red when the collar is properly seated and charging; it will turn green when charging is complete. The collar will achieve a full charge in 2-3 hours. Each charge can last up to 100 hours of continuous use. Battery Caution: Do not charge your collar every night. Frequent charging can have a negative effect on your collar's battery. We recommend the collar be used until the collar light blinks red. ReadyTestTM feature When you remove the collar from the charging cradle, the unit will automatically go into self-test mode for about 8 seconds. The collar's internal diagnostics will check that the battery charge is full and that all circuits are working correctly. Do not touch the skin contacts during this test. ReadyTestTM gives you added confidence that your collar is working and ready to go. If Continuous Red: If the ReadyTestTM self-test fails, the unit will tone and the LED will glow solid red for 20 seconds. Replace in the charger for 5 seconds, then remove. If the unit continues to fail, call us at 1-800-826-5527. PerfectFitTM Test for Skin Contact When turning the collar ON, hold thetbutton for 3 seconds. The collar will go into PerfectFitTM mode. The collar will emit a click tone as the contacts touch your dog's skin. A proper fit will be acknowledged with 5 consecutive click tones. To skip the PerfectFitTM test, just turn the collar ON by pressing thetbutton less that 3 seconds. The collar will function normally, bypassing the PerfectFitTM test. [. . . ] Realize that because dogs have unique temperaments, there is no way of knowing how your dog will react to the introduction of a remote training collar system. For the safety of your dog, a long lead should be used during initial training so you have control of the situation. If you have reason to believe that your dog may pose a danger to others, harm itself, or react adversely to the collar, do not rely solely on this product to train your dog. If your dog shows signs of growling, snarling or biting while using the collar, stop immediately. Aggression in dogs has many causes. [. . . ]