User manual INTEGRA DTR-80.2

[. . . ] AV Receiver DTR-80. 2 DTR-70. 2 Instruction Manual Introduction WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Important Safety Instructions 1. Install in accordance with the manufacturer's instructions. [. . . ] With Edge Enhancement, you can make the picture appear sharper. Full: Zoom: Wide Zoom: Smart Zoom: En 63 Mosquito NR*2*3*4*6 Off: Mosquito noise reduction off. With Mosquito Noise Reduction, you can remove the shimmering or haziness that sometimes appears around objects in the picture. Mosquito noise can be an issue with overly compressed MPEG content. Random NR*2*3*4*6 Off: Random noise reduction off. With Random Noise Reduction, you can remove indiscriminate picture noise, such as film grain. Block NR*2*3*4*6 Off: Block noise reduction off. With Block Noise Reduction, you can remove the block distortion that sometimes appears in the picture. Block noise can be an issue with overly compressed MPEG content. Resolution*2*4 Through: Select this to pass video through the AV receiver at the same resolution and with no conversion. Auto: Select this to have the AV receiver automatically convert video at resolutions not supported by your TV. When the "Monitor Out" is set to "Analog", this setting will be changed to "Through". 480p (480p/576p): Select this for 480p or 576p output and video conversion as necessary. 720p: Select this for 720p output and video conversion as necessary. 1080i: Select this for 1080i output and video conversion as necessary. 1080p: Select this for 1080p output and video conversion as necessary. When the "Monitor Out" is set to "Analog", this setting will be changed to "1080i". 1080p/24: Select this for 1080p output at 24 frames per second and video conversion as necessary. When the "Monitor Out" is set to "Analog", this setting will be changed to "1080i". You can specify the output resolution for the HDMI outputs and have the AV receiver upconvert the picture resolution as necessary to match the resolution supported by your TV. Available only when "Source" has been selected in the "Resolution" of the "Monitor Out" setting ( 51). Brightness*1*2*4 ­50 to 0 to +50 With this setting you can adjust the picture brightness. Contrast*1*2*4 ­50 to 0 to +50 With this setting you can adjust contrast. Hue*1*2*4 ­20 to 0 to +20 With this setting you can adjust the red/green balance. [. . . ] *-** No media" is displayed on the front display of the AV receiver. (Alpha-numeric characters on the front display are denoted by asterisks. ) See the following table and take appropriate action. Errors during update via USB Error Code *-10, *-20 Description USB storage device is not detected. Make sure the USB flash memory or USB cable is properly connected to the USB port. [. . . ]