User manual INTEL DESKTOP BOARD DG43RK

[. . . ] Intel Desktop Board DG43RK Product Guide Order Number: E88305-001 Revision History Revision -001 Revision History First release of the Intel Desktop Board DG43RK Product Guide Date February 2010 Disclaimer INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH INTEL PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY THIS DOCUMENT. EXCEPT AS PROVIDED IN INTEL?S TERMS AND CONDITIONS OF SALE FOR SUCH PRODUCTS, INTEL ASSUMES NO LIABILITY WHATSOEVER, AND INTEL DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY, RELATING TO SALE AND/OR USE OF INTEL PRODUCTS INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. Intel products are not intended for use in medical, life saving, or life sustaining applications. [. . . ] Secure the card?s metal bracket to the chassis back panel with a screw (Figure 18, B). Figure 18. Installing a PCI Express x16 Card 43 Intel Desktop Board DG43RK Product Guide Removing the PCI Express x16 Card Follow these instructions to remove the PCI Express x16 card from the connector: 1. Observe the precautions in "Before You Begin" on page 29. Remove the screw (Figure 19, A) that secures the card?s metal bracket to the chassis back panel. Push the card ejector lever down using the tip of a pencil or similar tool (Figure 19, B) in the notch. This will release the card from the connector (C). Pull the card straight up. Figure 19. Removing a PCI Express x16 Card 44 Installing and Replacing Desktop Board Components Connecting a PATA (IDE) Cable An IDE cable can be used to connect two IDE drives to the Desktop Board. The cable supports the ATA-66/100 transfer protocol. Figure 20 shows the correct installation of the cable. NOTES ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive. Do not connect an ATA device as a slave on the same IDE cable as an ATAPI master device. For example, do not connect an ATA hard drive as a slave to an ATAPI CD-ROM drive. Observe the precautions in "Before You Begin" on page 29. Attach the cable end with the single connector (blue) to the Intel Desktop Board (Figure 20, A). Attach the cable end with the two closely spaced connectors (gray and black) to the drives (Figure 20, B). Figure 20. Connecting the IDE Cable 45 Intel Desktop Board DG43RK Product Guide Connecting Serial ATA (SATA) Cables SATA cables support the Serial ATA (SATA) protocol. Each cable can be used to connect a single SATA drive to the Desktop Board. Observe the precautions in "Before You Begin" on page 29. Attach one end the SATA cable to one of the SATA connectors on the board (Figure 21, A). Attach the other end of the SATA cable to the SATA drive (Figure 21, B). Figure 21. Connecting a Serial ATA Cable 46 Installing and Replacing Desktop Board Components Connecting to Internal Headers Before connecting cables to the internal headers, observe the precautions in ?Before You Begin? [. . . ] Japan VCCI (Voluntary Control Council for Interference) mark. S. Korea KCC (Korean Communications Commission) mark. Includes adjacent KCC certification number: CPU-DG43RK (B). Taiwan BSMI (Bureau of Standards, Metrology and Inspections) mark. Includes adjacent Intel company number, D33025. [. . . ]