User manual INTERMATIC UG28 MODULAR

[. . . ] Mount as close as possible to the electric panel or individual piece of equipment to be protected. The UG Modular device should be mounted on a flat vertical surface that can support the weight of the device. Consideration should be given to the available knockout positions in the panel when deciding where to locate the UG Modular device. All wire leads should be kept as short as possible to insure optimum operation. [. . . ] Grounded Phase or Corner Grounded Delta. 2 (2) L2 will be grounded in a 240 VAC FINAL CHECKOUT PROCEDURE 1. Make sure that the UG Modular cabinet is properly secured to the mounting surface. Make sure that conduit is securely connected and all fittings have been correctly tightened. Make sure that the door has been replaced on the UG Modular cabinet. Make sure that the high leg in `High Leg Delta' units is connected to the center fuse terminal identified with the red lead. CHECK all connections for proper tightness. CHECK the AC power feed for proper voltage. CHECK each module for correct installation. Each module should sit flat against the back-plate with the locking clips firmly engaged in the T-slots on each side of the module. Make sure that the replaceable fuses are properly seated and the fuse insulator panel is in place and properly secured. RESTORE electric power to the UG Modular unit circuit or equipment circuit. Check all indicator lights for proper illumination. If all indicator lights are not illuminated, turn off power and repeat Final Checkout Procedure steps 1 through 8. If all indicator lights are still not illuminated, contact Intermatic at 800-391-4555. OPERATION 1. The cabinet door should be closed and secured to prevent access by unauthorized personnel. The STATUS INDICATOR lights should be ON and visible through the viewing ports when the door is closed. The UG28 and UG30 Modular systems automatically react to transient surges and require no interaction by local personnel unless one or more indicator lights are out. ALARM CONDITIONS 1. Unit is in alarm condition of one or more indicator lights are not illuminated. Contact your electrical contractor if you are not authorized to work on line voltage equipment. Inspect the UG Modular unit for obvious signs of catastrophic failure. Check breaker(s) or disconnect switch to make sure that power is being supplied to the UG Modular unit. [. . . ] (3) Disclaimer of Warranty THE FOREGOING WARRANTIES ARE IN LIEU OF ALL OTHER EXPRESSED WARRANTIES. TO THE EXTENT ALLOWED BY LAW, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY. (4) Limitation of Remedies IN NO CASE SHALL INTERMATIC BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES BASED UPON BREACH OF WARRANTY, BREACH OF CONTRACT, NEGLIGENCE, STRICT TORT, OR ANY OTHER LEGAL THEORY. SUCH EXCLUDED DAMAGES INCLUDE, BUT ARE NOT LIMITED TO, DAMAGE TO SOFTWARE, LOSS OF DATA, LOSS OF PROFITS, LOSS OF SAVINGS OR REVENUE, LOSS OF USE OF THE PRODUCT OR ANY ASSOCIATED EQUIPMENT, COST OF CAPITAL, COST OF ANY SUBSTITUTE EQUIPMENT, FACILITIES OR SERVICES, DOWNTIME, THE CLAIMS OF THIRD PARTIES INCLUDING CUSTOMERS, DAMAGE TO PROPERTY AND PERSONAL INJURY. [. . . ]