Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual INTERMATIC WL150HPS. We hope that this INTERMATIC WL150HPS user guide will be useful to you.
Lastmanuals help download the user guide INTERMATIC WL150HPS.
Detailed instructions for use are in the User's Guide.
[. . . ] Follow all applicable electrical codes and regulations.
Read instruction sheet carefully before installing fixture. Retain instructions for future reference.
WARNING: Electric shock hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. WARNING: Fire hazard
USE MIN 90ºC SUPPLY CONDUCTORS. [. . . ] If supply voltage is lower, cap wire marked 277V with appropriate twist on wire connector and strip fixture wire marked with matching voltage. (See Figure 3)
240 V 277 V X3 IGN-01 X1
CAP
208 V 120 V COM
LAMP
Figure 3
COM
X3
5. Feed the matching voltage fixture wire, fixture wire marked "COM", and bare copper fixture grounding wire out of the fixture. Confirm all unused voltage fixture wires are appropriately capped within fixture body. Using provided twist on or other approved connectors, connect the fixture wires to the supply wires. Connect the selected voltage fixture wire to the Black (hot) supply wire. Connect the White fixture wire marked "COM" to the White (neutral) supply wire. Connect the bare copper (fixture ground) wire to the supply grounding wire. Install reflector and secure with (2) screws. Screw lamp into lampholder until finger-tight. Install, close, and secure lens cover with (2) screws making sure that the gasket is properly seated. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photocontrols, etc. ) with silicone sealant. To operate, restore power to the circuit and switch light on.
LAMP REPLACEMENT CAUTION: Use lamp of correct type and wattage as specified on fixture.
1. Turn off power at circuit breaker or fuse box. Loosen (2) screws and swing hinged fixture lens door open. Remove old lamp and replace with new lamp of correct type and wattage. [. . . ] ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE INTERMATIC WL150HPS
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual INTERMATIC WL150HPS will begin.
