User manual IOGEAR GHE835C

[. . . ] 3. 5" Combo IONTM Drive Hi-Speed Portable External Hard Drive FireWire 800/USB 2. 0 User Manual ® Thank you for purchasing IOGEAR's® IONTM Drive, one of the fastest and sleekest Hi-Speed portable external Hard Drives on the market. IOGEAR ® only manufactures high quality storage devices, so we are sure you will be satisfied with your purchase. IOGEAR® is dedicated to customer service and satisfaction, and wishes you the best with your new IONTM drive. To better serve you, IOGEAR® offers an array of additional USB 2. 0, USB, FireWire, KVM, and other peripheral products. [. . . ] Power Port 9 Installation If you purchased the enclosure only model (GHE835C), please follow these instructions on page 11 to install your 3. 5" Hard Disk Drive. WARNING: Opening an IONTM Drive with a built-in Hard Drive (GHD835C80, GHD835C120, etc. . . ) WILL VOID YOUR WARRANTY. For assistance with your hard drive, please contact your IOGEAR Service Support representative. 10 Installation Hardware Installation: Attention!Please take all proper Electro Static Discharge (ESD) precautions during the installation of your new hardware. For further information on ESD please visit http://www. esda. org. 1 Please have the following ready 1 Phillips screw driver (not included in the package) Step. 2 Remove Base Remove Phillips screw from bottom edge of side panel. 11 Installation Step. 3 Remove side panel in a backward direction. 4 Remove two screws in hard drive retention bracket. 12 Installation Step. 5 Remove hard drive retention bracket from enclosure. Slide in an upward direction towards the top of the enclosure to free the drive bracket. Lift the drive bracket out of the enclosure. 13 Installation Step. Side panel Enclosure with one side panel attached Drive bracket One small screw Two long screws with nylon collar AC adapter AC adapter cord USB 2. 0 A to B cable 1 FireWire (9-pin to 9-pin) cable 2 3 4 5 6 7 8 9 14 Installation Step. 7 Attach the hard drive into the hard drive bracket. Screw the four screws into the drive bracket that were provided with the hard drive. 15 Installation Step. 8 Attach the signal cable to the hard drive with bracket attached. Attach the power cable to the hard drive in the power socket. Place the bracket with drive attached into the enclosure over the base plate. Line up the holes in the bracket with the base plate 16 Installation Step. 9 Insert the two previously removed screws through bracket, tighten to secure bracket to base plate. 10 Place the side cover on the enclosure and secure by sliding in forward direction. Now replace the button screw. 17 Installation Step. [. . . ] Please be ready to give a brief description of the problem, and what you were doing when the problem occurred, before calling Service Support. The Service Support representative will be able to serve you much quicker if you are prepared to answer the following questions listed below. If so, what are the steps necessary to reproduce the problem When does the problem occur?What have you already tried to get the problem resolved? [. . . ]