User manual IOGEAR GME225B

[. . . ] All other brand and product names are trademarks or registered trademarks of their respective holders. IOGEAR® makes no warranty of any kind with regards to the information presented in this document. All information furnished here is for informational purposes only and is subject to change without notice. IOGEAR® assumes no responsibility for any inaccuracies or errors that may appear in this document. [. . . ] The procedures below may be different for you, depending on the Bluetooth software you are using. If you need additional help, please consult the manual for your Bluetooth software. Keep in mind that for the initial configuration, the Bluetooth mouse will not be functional and that you will need to use a different mouse. 9 9 Installation WINDOWS SYSTEMS In the example below, the Bluetooth software used was Widcomm stack version 1. 4. 2. Make sure your computer is Bluetooth-enabled and that it supports the Bluetooth HID profile. Open your Bluetooth software (My Bluetooth Places, in our example) 4. Press and hold the Connect button located under the mouse for approximately five (5) seconds; this will set the mouse in discovery mode. Start the search for Bluetooth devices (Search for devices in range) 6. The IOGEAR Bluetooth Mini Mouse should be listed as shown in the image. If the mouse is not detected, repeat step 4 and search for your Bluetooth mouse again. 10 Installation 7. Right-click the IOGEAR Bluetooth mouse and select "Pair Device. " When prompted to enter a pass key, enter "1234". Your computer and mouse should now be paired. Next, right-click on the mouse icon and select "Connect Device" and when prompted to connect, click Yes. 11 11 Installation 9. You should now be able to use the IOGEAR Bluetooth Mini Mouse. Once you have connected and paired your mouse with your Bluetooth-enabled computer, you don't need to repeat this procedure. Even if you turn on/off the Bluetooth mouse or shut down your computer, the mouse will still connect to the computer when both devices are turned on. 12 12 Inst Installation MICROSOFT BLUETOOTH STACK (Windows XP SP2) The instructions below apply to Windows XP systems with Service Pack 2 installed. Make sure that your computer is Bluetooth-enabled and that the Bluetooth icon shows on your traybar 2. Right-click on the Bluetooth icon and select "Add a Bluetooth Device. " 13 13 Installation 3. Before proceeding with the Bluetooth Wizard, please do the following: · · Switch ON the Bluetooth mouse Press and hold the "connect" button underneath the mouse for five (5) seconds and then release Click the checkbox "My device is setup and ready to be found" and then click Next. · 14 Installation 4. Your computer will scan for Bluetooth devices in your area and display all found devices. On this window, you should see "Bluetooth Mouse" as shown below. Select the mouse and click Next to continue. 15 Installation 5. To pair with the Bluetooth mouse, select "Use the passkey found in the documentation" and enter the PIN code "1234". [. . . ] You don't need to turn off the power, and you can use the mouse when it is charging the batteries. A completely depleted battery requires 10 hours to charge. 24 18 Specification Function Battery Type Frequency Band Interface Operating Range Power Resolution Amps Voltage Specification Ni-Mh 2. 4 Ghz Wireless 66 ft. (20m) < 100mA 2. 4 V 800 dpi Specification 25 19 Radio & TV Interference Statement WARNING!!!This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. [. . . ]