User manual IOGEAR GPSR01U

[. . . ] Wireless USB Print Server 1 Port User Manual (GPSR01U) ® Welcome Thank you for purchasing one of the most feature-rich wireless print servers on the market. IOGEAR®'s Wireless USB Print Server's are first rate connectivity accessories designed to help reduce the frustration of dealing with cables in your home or office. IOGEAR®'s palm sized single-port Wireless USB Print Server allows any networked computer to wirelessly share a USB printer. We hope you enjoy using your IOGEAR® Wireless USB Print Server, another connectivity solution from IOGEAR®. ©2004 IOGEAR. [. . . ] If you were using DHCP before, you will select it from the Configure menu, and then click Apply Now. You may now close the Network Preferences. Move the switch on the top of your Wireless Print Server from Ad Hoc to Standard-mode. In System Preferences, select Printers (or Print & Fax) 38 Macintosh Installation 29. Under the Printers Tab, select Set Up Printers. . . Queue Name ­ Leave blank for default. 30. In the top pull down box, select IP Printing. It will not require you to enter an IP address and will install the same. Printer Type ­ Leave as LPD/LPR Printer Address ­ This is where you will type in the IP address you entered in the Wireless Print Server setup (ex. 192. 168. 1. 254) 39 Macintosh Installation 32. Under Printer Model, select the model of printer you have. Your printer will is now installed. Please Note: Your Print Server is now installed and should function properly. If you have any difficulties, please do not hesitate to contact us for assistance. Click Add when finished. 40 Changing SSID on Print Server Changing the SSID on the Print Server To change the SSID on the Print Server, you must wirelessly connect to the print server in AD-HOC (Computer-to-Computer) mode while the Print Server is in a Diagnostic mode, unplug the unit, flip the DIP switch to the right side, the side near the power connector, and plug the unit back. You need to change the properties of your wireless card to Ad-Hoc and change the SSID to match the wireless Print Server's SSID, WLAN-PS. Right-click on My Network Places and click on properties. 41 Changing SSID on Print Server 2. Next right-click on the wireless network connection and click on properties. In the general tab click on the wireless networks tab. 42 Changing SSID on Print Server 4. Take note of the name that is shown for your wireless router. In the example below is "linksys", we are going to need that information later. Click on the "Advance" button. Choose "Computer-to-computer (ad-hoc) networks only. " Then select the Close button. 43 Changing SSID on Print Server 6. [. . . ] Once it restarts, it will bring you back to the homepage. 69 Un-installation Uninstalling the PSAdmin on Windows PC To help users easily remove all installed software components of the PSAdmin from their Windows PC, the PSAdmin software comes with an un-installation wizard that can automatically remove the software components from their Windows PC systems in minutes. Please follow the directions listed below to proceed with the un-installation procedure. Select Network Print Monitor for Windows 95/98/NT/2000/XP and click Change/Remove button. The un-install wizard program will be launched. After the PSAdmin is removed, the print server is no 6. [. . . ]