User manual IOGEAR MINIVIEW GCS602

[. . . ] Classic is a registered trademark, licensed to Apple Computer, Inc. Finder is a trademark of Apple Computer, Inc. All other brand and product names are trademarks or registered trademarks of their respective holders. IOGEAR makes no warranty of any kind with regards to the information presented in this document. [. . . ] If your computer uses a standard DVI connection socket, you will need a DVI-D to ADC adapter (purchased separately), in order to plug the cable into the ADC port. It consists of an integrated power supply with an AC wall power cord and a Y cable that connects to both the DVI and USB ports on your computer (see the installation diagram on p. If you use the DVI-to-ADC adapter make sure that the adapter and the ADC VGA card of the PC system/s, are both digital or both analog devices. ADC extension cables can be used to increase the distance from the Miniview ADC to up to 33 feet (10 meters). 5 Pictorial Introduction Front View 1 3 2 1. Online LED indicators Each CPU Port has a corresponding LED. The LED lights ORANGE when the connected computer is powered on. Selected LED indicators Each CPU Port has a corresponding LED. The LED lights GREEN when its port is selected 3. CPU Port Indicator/Selection Buttons 6 Pictorial Introduction Console View Computer Side 4 5 6 4. ADC Console Connector Your ADC flat panel display cable plugs in here 5. ADC Connector 1 This cable plugs into the ADC port on the computer you are designating as Computer 1 6. ADC Connector 2 This cable plugs into the ADC port on the computer you are designating as Computer 2 7 Installation 1. Make sure that power to all the devices you will be connecting up has been turned off. You must unplug the power cords of any computers that have the Keyboard Power On function. Otherwise, the switch will receive power from the computer. To prevent damage to your equipment due to ground potential difference, make sure that all devices on the installation are properly grounded. Consult your dealer for technical details, if necessary. Step 1. Plug the ADC cable from the ADC display into the Console port connector of the GCS602 unit. 8 Installation Step 2. Plug your USB keyboard and USB mouse into the USB ports on the back of the ADC display. 9 Installation Step 3. [. . . ] Turn off the power to the connected computers. Unplug each power wall cord from the computers. Unplug the ADC cables from the computers and the Apple display. Important: Failure to follow the above Powering Off steps will result in damage to the connected equipment. 13 Troubleshooting OSD Operation Symptom Keyboard not responding Possible Cause Loose cables Action Check all keyboard cable connections to make sure they are completely sealed in their sockets Unplug the keyboard from the Console Keyboard Por t, then plug it back in. Turn off both computers (see Powering Off p. 13), wait five seconds, then turn the computers back on. [. . . ]