User manual IQBOARD PS

[. . . ] IQBoard ET & PS User Manual Copyright(C) 2003-2010 Fuzhou Returnstar Technology Co. , Ltd. Web: www. recoverystar. com; www. iqboard. net Tel: 0086-591-87274373 Fax: 0086-591-87274383 E-mail: master@recoverystar. com Important Statements This manual is for IQBoard ET and IQBoard PS. The "Whiteboard" or "Interactive Whiteboard" in this manual all refer to IQBoard ET or IQBoard PS. The "Electronic Pen" and "Electronic Pointer" are used for IQBoard ET. [. . . ] You don't need to set the hard hotkeys. 6. 3 Enable Touch Recognition Touch Recognition allows the whiteboard to sense the difference between a pen, finger and palm of the hand. You can write and draw with the pen, move objects with your finger, and erase with the palm of your hand all at the same time -- no tool switching required. To determine whether your interactive whiteboard supports Touch Recognition, please refer to About Model. To enable Touch Recognition function 1. Select "Start > Programs > IQBoard ET & PS Drivers >Touch Recognition Setting". Select the Enable Touch Recognition of IQBoard PS V7. 0 check box. After you enable the Touch Recognition, you can use this function. When using this function, if the whiteboard often misinterprets your intent, you can customize Touch Recognition's sensitivity to suit your style. Before set up touch recognition function, please specify the whiteboard size. The default setting is 60-80 inch whiteboard. To customize the Touch Recognition's sensitivity: 1. Every time you touch the whiteboard with your pen, finger or palm, the whiteboard acquires a value, based on which one of the 3 functions will be performed: Write, Select and Erase. Move the 2 sliders to change the value range for the 3 functions. The wider the value range, the easier you can perform the related function. Test the Touch Recognition's sensitivity by pressing the testing area with pen, your finger and palm. If the whiteboard misinterprets your intent, adjust the sliders as detailed above. Click "Ok" to save your settings. To reset Touch Recognition's sensitivity to default settings, click "Defaults". Chapter 7 Use IQBoard 7. 1 Basic Operations For IQBoard PS, you can use the enclosed writing pen or your finger to write or perform mouse function. For IQBoard ET, you can use the enclosed electronic pen or electronic pointer to operate. Following are the tips for some basic operations: Single-click If you use pen or finger, press the surface with pen tip or finger tip at proper strength. If you use electronic pointer, touch the surface with the electronic pointer tip, then press the interactive button on the pointer body. Double-click If you use pen or finger, press the surface twice with pen tip or finger tip at proper strength. Please make sure you press at the same point. If you use electronic pointer, touch the surface with the electronic pointer tip, then press the interactive button on the pointer body. Right-click If you use pen or finger, press the surface with pen tip or finger tip, and hold for 2 seconds to popup the right-key menu. [. . . ] For the interactive whiteboard that support normal marker, you can use normal whiteboard eraser and wet cloth to clean. Prompt: Clean the frequently used whiteboard once a week to keep the best definition. 3. Please do not use sharp or pointed objects to scratch the surface and frame, otherwise the scratched part may be damaged, and won't work normally. During the usage, do not knock the surface fiercely to avoid the damage of whiteboard surface and electronic pen (writing pen). You can use sand wax to eliminate the scratch on the surface, and use dry cloth to clean out. [. . . ]