User manual IRIDIUM 9505A

[. . . ] 9505A-kgTOC. fm Page iii Wednesday, November 3, 2004 9:33 PM Contents Safety Information. . 70 Calling, Modifying, or Erasing an Entry . . 73 iii 9505A-kgTOC. fm Page iv Wednesday, November 3, 2004 9:33 PM Preventing Access to the Phone Book . 75 Viewing the Last Ten Calls Made or Received . [. . . ] Enter your bar password, and then press O. Enter the new bar password, and then press O. Enter the new bar password again to confirm, and then press O. Tip: If you are changing the password for the first time, use the password 0000. Using Calling Features 99 10CallRelated-kg. fm Page 100 Wednesday, November 3, 2004 9:37 PM Getting to Call Related Features. . . 1. Press M until you see Call Related Features, and then press O. 2. Press M to scroll to one of the features described below. You will see the feature name, followed by Select?. Viewing the Battery Meter Use this feature to check the charge level on your battery. Follow the steps in "Getting to Call Related Features. . . " to scroll to Show Battery Meter, and the press O to select. You will see the battery meter: Battery Quit? Low Charge Battery Quit? High Charge You may also see one of the following messages: Message Description The battery is being charged. You have an unapproved battery inserted in your phone. Charging Battery Fast Charge Completed Invalid Batt. 2. Press and hold C to exit. 100 Using Calling Features 10CallRelated-kg. fm Page 101 Tuesday, November 9, 2004 10:57 PM Viewing Signal Strength Use this feature to check the strength of the signal that your phone is receiving from the Iridium satellite network. Follow the steps in "Getting to Call Related Features. . . " to get to Show Signal Strength. You will see Checking Signal. . . . The signal strength indicator is located in the upper left corner of the display: rx Signal strength is sampled every four to five seconds; the indicator shows the average strength for the last three samples. The more segments displayed in the bar graph, the stronger the signal. Five bars indicate full signal strength. The indicator shows the tower icon but no bars when the signal is weak. Press and hold C to exit the menu. Using Calling Features 101 10CallRelated-kg. fm Page 102 Wednesday, November 3, 2004 9:37 PM Getting to Call Related Features. . . 1. Press M until you see Call Related Features, and then press O. 2. Press M to scroll to one of the features described below. You will see the feature name, followed by Select?. Deactivating Pending Call Drop Signal Under rare circumstances, due to system overcapacity or a satellite outage, a satellite may not be available to take your call. When this happens, your phone notifies you with a series of three consecutive tones and displays Pending Call Drop. The tones continue periodically until a new satellite moves into range or the call is dropped. [. . . ] Equipment needing service should be returned to your Service Provider or Point-of-Sale, not Iridium. SERVICE WORK PERFORMED BY SERVICE CENTERS NOT AUTHORIZED BY IRIDIUM TO PERFORM SUCH WORK WILL VOID THIS WARRANTY. 182 Warranty Information 22Warranty-kg. fm Page 183 Wednesday, November 3, 2004 9:41 PM All Products shipped to Iridium's authorized Warranty Service Center must be shipped with freight and insurance prepaid. Purchaser must include with the Product a bill of sale, a lease, or some other comparable proof of purchase, the name and location of the installation facility, if any, and most importantly, the Purchaser's name, address, and telephone number and a written description of the problem. Product that is repaired or replaced under this warranty shall be returned to Purchaser at Iridium's expense for the freight and insurance, and at Purchaser's expense for any applicable duties or other charges. [. . . ]