User manual IRIS CAN EXECUTIVE 4 DUPLEX

[. . . ] Introduction This User Guide helps you get started with the IRIScan Executive 4, a mobile duplex scanner. The default scan settings of the IRIScan Executive 4 are the following:  Please read this guide before operating this scanner and its software. All information is subject to change without prior notice. The software delivered with this scanner is:  Readiris Corporate 14 Cardiris 5 Button Manager Capture Tool For detailed information about the full range of features of Readiris, Cardiris, the Button Manager and the Capture tool, see their corresponding documentation on www. [. . . ] WARNING: If the calibration failed, the led will be flashing and an error message will be displayed on the screen. Disconnect and reconnect the scanner and then repeat the calibration. 8 Quick User Guide – IRIScanTM Executive 4 5. 2 Cleaning the scanner In order to maintain an optimal scan quality and prevent dust accumulation, it is recommended you clean the scanner (outer casing and feed rollers) approximately every 200 scans, or if vertical lines or stripes appear on the scanned image. ρ® Use only the recommended and supplied tools to clean the scanner. WARNING: Do not use any solvents or corrosive liquid (i. ) to clean any part of the scanner, otherwise the plastic material may be permanently damaged. Open the cover by holding the scanner with one thumb on the feeder and another thumb on the cover. Carefully and firmly press your thumb into the feeder and then raise the cover. This will cause the top of the scanner to release from the bottom of the scanner. Gently wipe the glass and feed rollers on the scanner, and the CIS cover with the cleaning cloth (included). 1 Clearing a Paper Jam When a document is jammed inside the feeder the scanner led blinks green. To clear a jam from the feeder, press and hold the Power button for 3 seconds to power off, then press quickly to power on again. The jammed document will be fed through automatically. If the document is still jammed, follow these steps to remove it: 1. Open the cover by holding the scanner with one thumb on the feeder and another thumb on the cover. Carefully and firmly press your thumb into the feeder and then raise the cover. This will cause the top of the scanner to release from the bottom of the scanner. Close the cover and reinsert the item to rescan. 10 Quick User Guide – IRIScanTM Executive 4 6. 2 Questions and Answers Question: Answer: Why doesn’t my scanner power on Make sure the scanner is connected to your computer using the provided USB cable. Question: Answer: Why does my scanned image always come out too dark? [. . . ] if a battery is swallowed , seek medical treatment immediately. If battery acid leaks from a battery, wipe it off with a cloth and replace the battery with a new one. Use alkaline, lithium or Ni-MH batteries (AA or AAA size) for the IRIScan Book 3 and IRIScan Book Executive 3 respectively. Do not use new and old batteries together or mix different types or brands of battery. [. . . ]