User manual IROBOT LOOJ

[. . . ] Gutter Cleaning Robot www. irobot. com   Important Safety Instructions Looj is a gutter cleaning device, use only as intended. For residential use only. • Read all instructions before using Looj. •  This device has been tested and complies with FCC rules. Changes or modifications not expressly approved by the manufacturer will void your authority to operate this product. [. . . ] Looj batteries are designed to power Looj through 150 linear feet of gutter on a single charge, including the time to drive Looj back and forth during cleaning. Do not leave Looj’s battery plugged into the charger for more than 24 hours, as it may reduce the battery life. For long term storage, iRobot recommends that the battery be fully charged then removed from the robot and stored in a cool, dry place. Battery Tips • Remove all batteries and store in a cool dry place when not in use. •  not leave batter y charging for more than 24 hours. •  The batter y naturally looses charge while being stored. After storing for a season without charging, you will need to recharge the batter y for 24 hours prior to using. •  Batter y life can be improved by only charging the batter y when it is fully depleted. See www. irobot. com/support for more details on the Looj batteries and charging. To install battery pack: 1.  Loosen screws and remove battery door 2.  Make sure the battery end caps are on the battery. The end caps ensure a tight fit of the battery into the compartment. 3.  Connect the battery connector to the connector inside the robot’s battery compartment and insert the battery into the robot battery compartment 10 iRobot Looj Owner’s Manual www. irobot. com 11   Using the Remote Control Handle The remote control handle detaches from Looj and is used to command the robot from a distance of up to 75 feet, depending upon interference and environmental conditions. The remote control handle keeps your hands clean and makes it easy to place the robot in and out of the gutter using only one hand. Install two AAA alkaline batteries (not included) in the remote control handle before operating. Always use the same brand of batteries in the remote control handle. Don’t mix battery types or brands. Use fresh batteries for maximum performance and range. Insert AAA batteries into the remote control handle as shown. To remove the remote control handle from Looj: Press release trigger and slide remote control handle away from auger. Release Trigger Attaching the Auger To attach the remote control handle to Looj: 1.  Hold the remote control handle and align the front edge with the mark on the robot. 2. Slide the remote control handle onto the robot. Push the auger onto the robot shaft until you feel it snap into place or hear a click. 3. Let go when you hear a snap indicating that handle is in place. TIP: Make sure handle is securely attached to the robot before picking  up the robot. 12 iRobot Looj Owner’s Manual www. irobot. com 13   Attaching the Looj Belt Clip The Looj belt clip is designed to hold Looj while you climb up and down the ladder. Always use the belt clip or the optional holster accessory (see below) when using Looj on a ladder. To use the belt clip, remove your belt and thread it through the belt slots. The robot hook should be on the bottom of the clip when attached to your belt. Attach the robot to the robot clip. Belt Slots Using iRobot Looj ® ™ Always test Looj before using it. Prior to using Looj, try driving forward and backwards. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. •   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]