User manual IROX BAROBEAM

[. . . ] 44 2. 3 Remote sensor (Temperature). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Set-up. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Extended operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46 4. 1 Weather forecasts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In these chapters you will find additional information about the functions 2- Graphic pressure history - One bar equals 1 hPa. This displays the pressure history of the past 24 hours. - If you change the pressure units (from hPA to inHG), the graph will remain the same. The only thing that vanishes is the scaling on the right side of the graph with the -4 to +4 hPa. - The graph can be displayed in 3 different ways: Dynamic stacking bars, increasing from -24 hrs. to 0 hrs. 4. 1 Weather forecasts This Irox device uses a high quality pressure sensor to measure barometric pressure and the respective changes. This information is then, using a by meteorologists specially developed algorithm, used to calculate a weather forecast for the coming 12-24 hrs. Eight different forecasts are possible: Static stacking bars, only the 0 hrs bar blinks Sunny Slightly cloudy Cloudy Rain Heavy rain Snow Heavy snowfall Thunderstorms /Stormy COMMENT: These calculated weather forecasts have a reliability of approx. The forecast is displayed, not the current weather. SUNNY means clear weather day and night. 4. 2 Air pressure indicator The indication of the air pressure depends on the setting of the sea level. If the setting is 0 meters, you will see the local measured pressure. To prevent this from happening each setting must be completed. RADIO CONTROLLED CLOCK RECEIVING LOGIC 1. As described in chapter 3 the time transmitted by the time signal transmitter DCF77 is automatically received when the batteries are icon will blink, if reception is good with waves if activated. The time signal reception takes about 3-10 minutes. During receiving the reception is poor without. then on again you can do so with the "setting". If you would like to switch the automatic time reception off and 3. During normal operation an automatic time reception will be activated daily at 0:00, 3:00, 6:00 and 12:00. As soon as the device has received a signal the time will be correctly adjusted and the 5. If reception is poor the icon will be displayed. You may then set the clock manually at any time. [. . . ] · Ideally the sensor should be placed 1. 25m (4 feet) over the ground respectively grass surface. Stone, asphalt, or tar surfaces can become extremely warm and thus falsify the measurement. · Heat sources such as a fireplace or heaters of any type must be avoided. · The display unit must be positioned within the transmitting radius of the sensor and away from the direct influence of heating or cooling apparatus. [. . . ]