User manual IROX HBR529

[. . . ] Once batteries are in place for the remote unit, they will start transmitting temperature and humidity readings at around 45 seconds intervals. The main unit will also start searching for signals for about two minutes once batteries are installed. 10 seconds upon successful reception , the outdoors temperatures and humidity will be displayed . The main unit will automatically update its readings at about 45-second intervals. [. . . ] It is not necessary and not possible to adjust the altitude of the weather station. After the initial start-up of the weather station, a first forecast will be made within the first 24 hours of operation. In periods of long stable weather conditions, it becomes difficult to make a reliable forecast. The weather forecast is solely calculated on the basis of barometric air pressure changes. The probability of a correct weather forecast is approximately 70% and is valid for an area of approx. 20-30 km around the location of the weather station. The forecast "Sunny" means at night "cloubless weather". Fogis not indicated by the weather station as this can occur with different weather conditions. If you travel with become impossible due to changes in altitude and location. You'll have to wait up to 24 hour so that the weather station can calculate a new forecast based on the conditions at the new location. 4a) HOW TO CHECK REMOTE AND INDOOR TEMPERATURES The wave display on the outdoors temperature indicates the reception of the remote unit is in good order. 3 Seconds the key [ ] to disable the automatic time signal reception. The reception signal [ ] will then disappear from the display. Repeat the same procedure to set single alarm. 6c) SNOOZE FEATURE When the alarm sound is on, press the snooze key enter snooze mode. After 8 minutes, alarm sound will be wake up automatically. The snooze cycle will be restarted if you press the snooze key again. If you leave the alarm sound on for 2 minutes, it will enter snooze mode automatically with maximum 3 times. 6d) HOW TO STOP AN ALARM Press [ALARM] on the unit to stop an alarm. 6e) ALARM FEATURE * Weekday Alarm The alarm sound will be activated and the icon will be flashed on weekday when it is armed and the alarm time is reach. * Single Alarm The alarm sound will be activated and the icon will be flashed once when it is armed and the alarm time is reach. Once it finished, it will be disabled automatically. [. . . ] Do not clean the unit with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuit. Do not subject the unit to excessive force, shock, dust, temperature or humidity, which may result in malfunction, shorter electronic life span, damaged battery and distorted parts. Do not tamper with the unit's internal components. [. . . ]