User manual IROX HTS33

[. . . ] The HTS33 offers absolutely unique features by interlinking two countdown timers as well as 5 different options in the alarm announcement and the start logic. Please read these instructions carefully to benefit fully of all features of this timer. Timer 1 - Display of the programmed value of timer 1 - The timer can be set up to a maximum of 9 hours 59 minutes and 59 seconds Indicates when the timer 1 is set to be repeated Indicates when the batteries are week Timer 2 - Display of the programmed value of timer 2 - The timer ca be set up to a maximum of 9 hours 59 minutes and 59 seconds Indicates when the timer 2 is set to be repeated Indicates when the interleave function between timer 1 and timer 2 is set Indicates when the interleave function between timer 1 and timer 2 is set to repeat the interleave cycle 2. 2 KEYS / SWITCH / BATTERY COMPARTMENT Rear view 2. OPERATING ELEMENTS 2. 1 LCD DISPLAY All functions are depicted on the liquid crystal display (LCD) in two windows (TIMER 1 and TIMER 2). Full-segment display 23 24 T1/T2 - Press to select the timer - The selected timer's icon or will flash on the display. Pos. 4: AUTO-START, SOUND OFF ­ The countdown will start automatically 5 seconds after the setting. [. . . ] Alarm sound off and the LED light flash above the display Pos. 5: SOUND & LIGHT OFF ­ Alarm sound off and the LED light off Battery compartment MIN SET - Press to set the minutes of the selected timer - Press and hold 3 seconds to roll the minutes setting - Press and hold 5 seconds to roll the minutes setting faster SEC SET - Press to set the seconds of the selected timer - Press and hold 3 seconds to roll the seconds setting - Press and hold 5 seconds to roll the seconds setting faster INTERLEAVE / REPEAT - Press to set the repeat timer (T1 or T2 ) - Press to set the interleave function (in T2 ) - Press to set the interleave repeat function (in T2 ) Important note: the interleave functions and can only be set in T2 !START / STOP / MEM - Press to start the countdown of the selected timer - Press to stop the countdown of the selected timer - Press to show the previous setting of the selected timer (after the countdown has reached 0:00:00) - Press and hold for 3 seconds to reset the selected timer to 0:00:00 MODE HTS33 provides 5 alarm modes. It is managed by sliding the switch for selection: Pos. 1: SOUND ON ­ Alarm sound on and the LED light flash above the display Pos. 2: SOUND OFF ­ Alarm sound off and the LED light flash above the display Pos. 3: AUTO-START ­ The countdown will start automatically 5 seconds after the setting. Alarm sound on and the LED light flash above the display 2 x 1. 5 batteries of the size AM-4 resp. "AAA" To open: slide lid in the direction of the arrow (indicated on the lid) after the stand has been removed. 3. Open the battery compartment of the display device and remove all insulation strips. Press START/STOP/MEM to stop the countdown Note: Even the icon is flashing, the countdown always starts with T1 4. 6 Setting a continuous interleave between T1 and T2 After setting the T1 and T2, press INTERLEAVE/REPEAT, until the icon shown on the display of T2. Press START/STOP/MEM to start the countdown of T1. Once the countdown of T1 completed, the T2 will start immediately. The T1 and T2 will be repeated continuously. Press START/STOP/MEM to stop the countdown Note: Even the icon starts with T1 is flashing, the interleave countdown always 5. CHANGE OF BATTERY : BATTERY CHANGE DISPLAY The batteries last for around 8-12 months. Depending on the usage of the appliance and the batteries used, this time can be slightly shorter or longer. In order to avoid a surprising and unpleasant interruption of operations, the battery symbol appears in the window of timer 1. This means that batteries are becoming too weak and need to be replaced. To change the batteries, please note Chapter 3 (Putting into operation). [. . . ] This means that batteries are becoming too weak and need to be replaced. To change the batteries, please note Chapter 3 (Putting into operation). Please only use new batteries and never mix old and new batteries. Please also remember that used batteries should not be thrown in the household rubbish bin but handed in at the designated collection points. [. . . ]