User manual IROX JKBA-1

[. . . ] Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Operating elements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 2. 1 LCD (display) and buttons front side. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 2. 2 Stand, battery compartment and button on back side. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] With this value you can meteorologically position your location with other available information (e. g. the isobar map on TV, Internet or in your daily newspaper). With the height adjustment setting you can also adjust any slight deviations to a precision measuring instrument and so to say calibrate the pressure sensor. As a rule: 5m more in height, pressure reading is increased by 1 hPa. Static line diagram, only the segment 0 hrs blinks 46 47 4. 4 Temperature / Moisture The display unit measures the temperature and relative humidity and receives additional measurements from the remote sensors included in the delivery. The temperature can be displayed in °C or °F. The comfort zone is calculated from the thermo/hygro measurements of the display unit. A frost warning is programmed on the remote sensor. When the temperature measured by the remote sensor drops below 3°C, the frost warning icon will appear on the display. 4. 5 Time function The time signal DCF 77 is transmitted by the atomic clock in Mainflingen near Frankfurt/Main. The long-wave transmitter has a range of up to 1500km. is displayed without waves you have reception problems. Please observe following points: If the time icon - There are fewer disturbances in the atmosphere during the night which increases the likeliness of reception. One reception per day is completely sufficient to ensure the preciseness of the clock by +/- 1 second - Make sure that the device is at least 2 meters (8 feet) away from possible sources of disturbance such as TV, computer, monitor, microwave etc. SEARCH FOR REMOTE SENSOR You can start the search for the remote sensor manually by pressing and holding the SYNC start to blink. The wave icon indicates the receiving status of the remote sensor signal: Icon Status Searching for the remote sensor signal Sensor signal successfully received No signal received for over an hour button for 3 seconds. The wave icon will - In rooms with concrete or metal walls (e. g. cellar rooms, modern office buildings etc. ) the receipt of the signal may be more difficult due to the shielding. In such cases find a better location for the device near a window. Sometimes it also helps to simply turn the device by 90°, thereby improving the alignment of the receiving antenna. Caution: During the setting procedure as described below you will exit the setting mode if more than 1 minute passes between pressing the buttons. The settings already made up to this point will then be deleted. To prevent this from happening each setting must be completed. RADIO CONTROLLED CLOCK RECEIVING LOGIC 1. [. . . ] A distance of at least 1 meter must also be maintained between sensor and display unit and other remote equipment. Remote equipment is, for example, cordless telephones, wireless headphones, baby monitors, mobile phones etc. 7. CARE OF THE DEVICE - Do not expose the device to extreme temperatures or direct sunlight over longer periods. - Avoid blows and shocks of any kind to the device. [. . . ]