User manual IROX LUNA 3

[. . . ] Directly after the activation of the batteries, all segments are displayed for a few seconds on the display. The LUNA 3 then begins with "12:00 am" on the display. SNOOZE / LIGHT - Press to turn on the backlight - Press and hold 3 seconds to set the snooze cycle (1-9 minutes) - During the alarm sound is on, press to start the snooze cycle. The icon will be shown ALARM LUNA 3 provides 5 modes for alarm sound. It is managed by sliding the switch for selection: Pos. [. . . ] The reception of the time signal takes about 3-10 minutes. If reception is bad, without. 29 30 2. As soon as the time signal has been successfully received, the time will automatically be set and the symbol will be activated. If time reception was not successful, the reception symbol is indicated without waves. In such case, you can also set the time manually (see directions in chapter 4. 1. 2). The LUNA 3 will independently try to receive a signal again during the night. NOTE: The radio controlled clock automatically synchronizes itself during the night (1:00, 3:00, 6:00, 9:00). This increases the chance for an undisturbed reception of time and accurate time even in locations where reception is a problem. 4. 1. 2 Manual setting LUNA 3 provides another option which allows you to adjust the clock manually, when there is no reception for the radio controlled clock signal. Press and hold the MODE button for 3 seconds, time mode 12/24 hr will be displayed. Press + or ­ button to set the hour. The symbol will flash during the snooze cycle. If the SNOOZE / LIGHT button is not pressed during the 2 minutes, the alarm sound will automatically switch off until the next morning (= 24hr OFF) 3. During the alarm sounding or during the snooze cycle (=blinking ), press the ALARM button. After pressing once the alarm is interrupted until the next morning (=24hr OFF; stops blinking). If you press the button a second time, the alarm will be completely deactivated. This means it will not sound the following morning!NOTE: If the snooze cycle of one alarm is active (e. g. AL2) starts within this cycle, then the first active alarm will go to 24hr OFF and the second alarm will be continued. 4. 2. 4 Setting the snooze cycle 4. 3 BACKLIGHT It is possible to use the background illumination when setting the alarm function. This can be very practical in dark bedrooms. Press the SNOOZE / LIGHT button to activate the background illumination before beginning. [. . . ] Depending on the usage of the appliance and the batteries used, this time can be slightly shorter or longer. In order to avoid a surprising and unpleasant interruption of operations, the battery symbol appears in the time window. This means that batteries are becoming too weak and need to be replaced. To change the batteries, please note Chapter 3 (Putting into operation). [. . . ]