User manual ITI ADVENT HOME NAVIGATOR SYSTEM REV B

[. . . ] 60-562-02, 60-562-05 $GYHQW +RPH 1DYLJDWRU 6\VWHP Document Number: 466-1318-ITI Rev. B February 2001 Contents Welcome . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 System Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 System Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When this happens, call your monitoring service and follow their instructions to prevent the fire department from being dispatched. Auxiliary or medical alarm--You must cancel the alarm within 5 (programmable) seconds to prevent the system from reporting to the monitoring service. Alarm Type Steps Response ALARM CANCELED Touchpad Access Code Tampering The system can be programmed to detect four or more incorrect access code entry attempts during any single session as unauthorized touchpad tampering. If this feature is enabled, the system will respond with a a KEYSTROKE VIOLATION trouble indication and a police alarm. If you know that this was done in error, contact the monitoring service and let them know. To cancel this alarm, Steps Response ALARM/REPORT CANCELED, SECURITY IS OFF To cancel an accidental alarm: Enter your primary ACCESS CODE. Police Alarm Enter your ACCESS CODE within 5 (programmable) seconds of the alarm start. Report canceled. Fire Alarm Enter your ACCESS CODE. then follow the instructions Report continues. from your monitoring service to prevent the police or fire department from being dispatched. Auxiliary Enter your ACCESS CODE or Medical within 5 (programmable) seconds of the alarm start. Alarm ALARM CANCELED If canceled soon enough - within 5 seconds (programmable) - the alarm will be canceled and the report to the monitoring station stopped. If not canceled soon enough, the monitoring service will dispatch the police. Police sirens will sound until the alarm is canceled. Ir To be on the safe side, call the monitoring service even if you think you may have canceled the false alarm in time to stop the report. Report canceled. Advent Home Navigator System 13 Security Protection Remote Phone Access Code Tampering Four incorrect attempts at entering an access code during any single operation session results in a TROUBLE indication. The system hangs up and will not allow further attempts for 24 hours or until the system has been disarmed via an on-site touchpad. Hang up and wait for 24 hours and try again or follow these steps at the premises: Steps Response Security Protection Turning Security Protection On Turning security protection on means arming the system against fire, intrusion, or other emergencies. You can arm the system to one of several levels depending on your needs throughout the day. Table 5 shows which sensors are active in the various arming levels. Table 5: Arming Levels Sensors: Active Arming Levels: Off Home Night Away Silent 1. Press 1, 1, ACCESS CODE. Trouble beeps stop. SECURITY MENU; SECURITY IS OFF Indoor sensors (motion, etc. ). Outdoor sensors (door/window) Environmental sensors (smoke, heat, carbon monoxide, etc. ). * 4 4 4 4 4 4 4 4 Trouble is acknowledged and further remote phone access is allowed. Phone Line Tampering If the phone line is cut, the system responds with a TROUBLE indication. To stop the trouble beeps: Steps Response 4 4 4 4 Press * to clear trouble indication. Trouble beeps stop. Arming to Night is like arming to Away, except a few designated indoor sensors remain disarmed (hallway outside your bedroom). This would allow you to walk from your bedroom to the kitchen or bathroom at night without needing to disarm the entire system. If the phone line is still faulty, the trouble beeps will start again within 24 hours (at the daily trouble indication time). The display continues displaying a flashing * until the trouble is fixed. Ir Arming to Home Arming to Home is used when you stay indoors but will be awake and active. To arm the system to home: Steps Response SECURITY MENU; ARMING LEVEL CHANGE; ENTER YOUR CODE; TO QUIT PRESS * PARTITION/AREA X ARMED HOME; OK TO EXIT Have the phone line repaired immediately and notify the monitoring service of the situation. Equipment/Sensor Tampering Tampering with system equipment, sensors, etc. (for example, opening enclosures), results in a TAMPER TROUBLE indication and/or an alarm. Replace any open system enclosures or sensor covers and clear the tamper indication. To clear a tamper/alarm indication: Steps Response 1. [. . . ] can void the user's authority to operate the equipment. FCC Part 15 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]