User manual ITI CARETAKER PLUS

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. [. . . ] To turn off Auto Phone Test, press: Note For UL 1635 listed systems, Auto Phone Test must be set to 001 days. Simon Security System 24 Delete--Option #--16--DONE. Option 17: Dialer Delay (Default = off) Determines whether the panel delays dialing programmed phone numbers before sending reports (on), or if dialing begins immediately (off). If Option 21: Opening (Disarming) Reports is on, the panel does not delay dialing if the system is disarmed before the delay time expires. The panel dials immediately for both the alarm and opening report. Note Regardless of this option setting, the panel always dials immediately for alarms from sensors in groups 0-8, 26, for alarms triggered by the control panel or remote handheld touchpad emergency buttons, and for programming, AC power failure, and low battery reports. Note For UL installations, the Dialer Delay must not exceed 45 seconds. The delay time can be set from 005 - 254 seconds (015 to 045 if Option 69: SIA Limits is on). To set Dialer Delay, press: Add--Option #--17--005 - 254--DONE. To turn off Dialer Delay, press: Delete--Option #--17--DONE. Option 18: Alarm Cancel Report (Default = 005 minutes) Sets the time frame that determines whether the panel reports an alarm cancel message to the central station. If the system is disarmed from an alarm state within the programmed time, the panel sends an alarm cancel message to the central station. An alarm cancel message is not reported if the system is disarmed after the programmed time expires. The time can be set from 005 - 255 minutes. When set to 255, the panel always reports alarm cancel messages. Turning off this option disables alarm cancel reporting. To turn on Alarm Cancel Report, press: Add--Option #--18--005 - 255--DONE. Depending on whether an answering machine exists at the panel location, off-site access to the panel can be done with a series of phone calls or just one. The following table shows the available settings. Ring/Hang/Ring Settings Setting 1 2 3 4 5 6 7 Off Control Panel answers after: ring/hang/ring or 10 rings ring/hang/ring/hang/ring or 10 rings ring/hang/ring/hang/ring/hang/ring or 10 rings 10 rings ring/hang/ring ring/hang/ring/hang/ring ring/hang/ring/hang/ring/hang/ring Disabled--no remote (off-site) access For off-site access where an answering machine does not exist, the user or ToolBox operator simply calls the panel location once and listens for 10 rings. The panel should answer after the tenth ring. For off-site access where an answering machine exists, the user or ToolBox operator must perform the following steps: Call the panel location. Wait at least 10 seconds but not more than 40, then call the panel location again. The panel should answer on the first ring. If set to 1 or 5, perform steps 1 - 3 once. If set to 2 or 6, perform steps 1 - 3 twice. If set to 3 or 7, perform steps 1 - 3 three times. To turn on Ring/Hang/Ring, press: Add--Option #--27--1, 2, 3, 4, 5, 6 or 7--DONE. [. . . ] Chime 14 Instant Interior: Interior doors 15 Instant Interior: Interior PIR motion sensors* 16 Instant Interior: Interior doors 17 Instant Interior: PIR motion sensors and Sound sensors* 18 Instant Interior Cross Zone: PIR motion sensors* 19 Delayed Interior: interior doors that initiate a delay before going into alarm* 20 Delayed Interior: PIR motion sensors that initiate a delay before going into alarm* 21 Local Instant Interior: 24 hour local alarm zone protecting anything that opens and closes. No Report 22 Local delayed interior: same as group 21, plus activation initiates a delay before going into alarm. No report. * 23 Local instant Auxiliary: 24 hour local alarm zone protecting anything that opens and closes. No report 24 Local Instant Auxiliary: 24 hour local alarm zone protecting anything that opens and closes. [. . . ]