User manual ITS TELECOM CGW-I INSTALLATION V3.18 RELEASE 1

[. . . ] CGW-I Installation and Operation Guide Version 3. 18 Release 1 April 2009 CGW-I Cellular Gateway BRI-GSM Interface Installation and Operation Manual VERSION 3. 18 ED. 1 APRIL, 2009 NOTICE No part of this document may be reproduced or transmitted in any form or by any means (electronic, photocopying, recording, or otherwise) without the prior written permission of ITS. The trademark and service marks of ITS, including the ITS mark and logo, are the exclusive property of ITS, and may not be used without permission. All other marks mentioned in this material are the property of their respective owners. [. . . ] If you are connected and click the Apply button, any changes you have made on the open screen are sent to the device if you are connected. To upload the configuration parameters that you may have changed and are currently displayed on the different CGW-I Manager screens, select: Communication Send Parameters. Note: You must be connected to the device to send parameters. A password must be entered CGW-I Cellular Gateway BRI-GSM : Installation and Operation Manual 25 the first time you make a connection to a specific CGW-I device before you can upload parameters to it. A gray bar will show the sending progress, followed by a message indicating whether the action was successful or not. Setting a Password A password must be filled in before reading or sending parameters. To change the administrator's password: 1. Enter the Current Password. Note: Password is not case sensitive. Entry is shown in asterisks (******). 2. Enter the New Password for the connected CGW-I. The password can be up to 16 characters. Re-enter the new password for confirmation. A message will appear indicating if the Password has been changed successfully or not. CGW-I Cellular Gateway BRI-GSM : Installation and Operation Manual 26 3. 4. System Menu The System menu lists the following options for configuring your CGW-I. · · · · · · ISDN Setting System Settings Channel Settings System Operation Prepaid Settings Control The following sections describe each option and the windows that they open. ISDN Settings The ISDN Settings window lets you set the parameters of the ISDN connection to your CGW-I device. Enter the following parameters: Field Connection Type Operation Mode TEI Value Parameter Select the BRI interface: NT or TE. When in AUTO TEI, the TEI value is not relevant. Enter TEI (Terminal Equipment Identifier) value: 0-63. The TEI value should only be entered when the Operation Mode is PTP. Enable when synchronization is done by another device which connects to the Synch-In port of the CGW-I. Disable when the CGW-I connects to a TE interface or the CGW-I Synch-In port is not used. For more details on external synchronization, see page 10. External Synchronization CGW-I Cellular Gateway BRI-GSM : Installation and Operation Manual 27 Field ISDN Version Parameter Select current ISDN-BRI version. Choose from: · Euro-ISDN (default) · Euro-ISDN ­ In Bound DTMF Dialing · Euro-ISDN ­ France · 1TR6 ­ Germany · Euro-ISDN ­ Germany System Settings The System Settings window lets you set the parameters for calls going through your CGW-I device. Enter the following parameters: Field Call Barring Dial Tone to PBX Call Duration Limitation Parameter Prevents SIM from accepting incoming calls or outgoing calls. Enables or disables the device's dial tone heard on an extension phone. Limits the length in minutes of outgoing calls to protect you from connections that are accidentally left open. [. . . ] Send notification for each system reset or initialization Send notification when CDR Buffer reaches 80% threshold. Send notification when the BRI link to your device is broken. Send notification when the Bad Reception Level counter reaches the threshold level set in the Statistics window. Send notification when a SIM card reaches 95% of the Remaining Prepaid SIM Time value, defined in the System Operation window. [. . . ]