User manual JACKSON HB28115

[. . . ] During wireless connection inside the home, if the wireless signal has been lost, you may have moved outside the range of LocationFreeTM TV. Move closer to the Base Station until you reach a place where the picture appears. During wireless connection inside the home, if a nearby device, such as another wireless access point, is operating on the same wireless channel as the signal from the Base Station, change the setting on the wireless access point. (See the "Wireless at Home" section below for more information. ) When Wireless or Wired LAN is selected in the "On the go mode", either connect through NetAV or change to the wireless connection. [. . . ] Make sure the DSL port and the TEL (telephone) port on the splitter are connected correctly. A: The majority of web sites are accessible using LocationFreeTM TV. However, web sites that require file types or plug-ins that are not supported by the LocationFreeTM TV cannot be displayed. However, even Flash and PDF files supported by the device may not display for some web sites. To view a web page using Flash, select the check box for "Enable Flash" in the "Web" settings window (see page 82 of the Operating Instructions). Web pages written in JavaScript will sometimes not display properly or will load repeatedly. Deactivate JavaScript by removing the check mark from "Enable JavaScript" in the "Web" settings window may allow the page to display properly. (Normally, leave "Enable JavaScript" selected and keep it enabled. ) For a complete listing of file formats and plug-ins supported by LocationFreeTM TV, please see the specification section of the Owners Manual. Mail LocationFree TV does not support ISP's that require proprietary software, such as AOL, United Online and Walmart. Please check with your provider. Q: Can I use any email service with LocationFreeTM TV? A: LocationFreeTM TV supports emails systems using the SMTP or POP3 protocols. LocationFreeTM TV does support email systems that require proprietary ISP software. A: If you have opened multiple tabs on the web screen, close some tabs. You can also turn the Monitor OFF and then ON again. Album Q: I saved an image but it cannot be displayed. A: Make sure you have selected the correct location where the image is saved. For images copied from a computer to a "Memory Stick" (LF-X1) or a CompactFlash card (HB28115) check if you have saved them in the appropriate folder in the Memory Stick or CompactFlash card) . Q: Why don't saved images appear in the top left of the "Picture List" window?A: Check the date and time settings and make sure they are correct. Q: A picture that I was drawing can no longer be seen. A: Did you adjust the "Brighter" or "Darker" functions while you were drawing?If you select "Brighter" or "Darker" repeatedly, the original picture may disappear depending on the color you used to draw your picture. Select "Restart" or "Return to hold" to begin another drawing. [. . . ] Q: Sometimes I can't seem to turn off the Monitor or Base Station. A: Hold down the power button for at least 3 seconds. This will force your LocationFreeTM TV to turn off. Q: I think I have a defective battery. Many times my battery runs out immediately after I have it inserted into the battery compartment on the stand. [. . . ]