User manual JACUZZI QUART DE CERCLE MAESTRIA

[. . . ] SAFETY" chapter) of the system to which the mini-pool is connected must be checked for efficiency. When you press the TEST key, the switch must disconnect. If this does not happen, disconnect the power supply immediately and contact a qualified technician. [. . . ] I Premium spas are equipped with the drain arranged as in If sufficient electrical energy is not available, an electronic energy consumption limiter can be activated from inside the electronics box. This operation can only be performed by authorized Jacuzzi® technicians and limits electricity consumption as follows: - medium alternative consumption: 4. 8 kW (when 2 hydromassage pumps are run, the electric heater goes off). 9 kW (when 1 hydromassage pump is run, the electric heater goes off). The customer must make provisions for a ground drainage point of suitable dimensions and that can be inspected for any cleaning that may be required. Net weight kg average fill litres maximum water volume litres total max. If you decide to attach the MaxiJacuzzi to the drain, it is advisable to connect upstream from the valve (for greater flow capacity) and to install a shutter valve near the drain in an accessible 1-1a-1b-1c, detail A1). I According to the type of installation chosen the ground drainage point will then be put into position. Natural or forced ventilation helps to maintain personal comfort and reduce damage to the building due to humidity. Jacuzzi Europe refuses all responsibility for any damage caused by excessive humidity or by overflowing water. consult a specialist for indoor installation. I Remember that it is compulsory to install a multiple-pole section switch with characteristics that are not less than the ones given in 2. I The installer must use suitable isolating cables, protected with a Sheath and/or tubes or pipes with characteristics which are not inferior to type H 05 VV-F, keeping in mind that the heater power supply is separete from that of the hydromassage pumps. The entry of cables into the mini-pool up to the electrical box ( 2) must be provided at point B or B1, depending on the customer's installation needs. Note: The lead sections must take account not only the systems absorption but also the cable path and the distances, the chosen protection systems and the specific regulations for fixed electrical systems in force in the country where the spa is installed. I The installer must comply with the above regulations, and also use It must be positioned in a place tion switch is compulsory ( that complies with safety regulations and, in any case, which cannot be reached by those using the spa. [. . . ] I The installer must comply with the above regulations, and also use It must be positioned in a place tion switch is compulsory ( that complies with safety regulations and, in any case, which cannot be reached by those using the spa. I The disconnection devices must be installed in the power sup- ) near the spa must be in compliance with legal standards and regulations in the country where the spa is installed. He must also guarantee compliance with the specific current standards for systems in the country in which the spa is installed. [. . . ]