User manual JANE INDY TEAM

[. . . ] They may have suffered structural damage, even if this is not visible to the naked eye. ARTSANA declines all responsibility for the incorrect use of this product. This is a , , Universal" child restraint. 04 series of amendments, for general use in vehicles and it will fit most, but not all car seats. [. . . ] After fitting KIT TRIO CAR to the carrycot, the carrycot can be fitted in the car. CAR SEAT REQUIREMENTS In order to fit the carrycot to the car seat, the car seat must comply with the following requirements: - it must be facing forward (Fig. 1); - It must be a rear seat fitted with at least two 3-point safety belts (Fig. 2) , approved to norm UNI/ECE 16 , or equivalent. HOW TO FIT KIT TRIO CAR TO THE CARRYCOT If KIT TRIO CAR has been purchased separately from the carrycot, please follow these assembly instructions before fitting the carrycot in the car. Lap belt The lap belt must be threaded through the two slots at the base of the carrycot (Fig. Fold the strap with the red sticker so as to leave the Velcro inside, then thread it through the right-hand slot (Fig. 4), and pull it out of the left-hand slot (Fig. Fasten the belt by placing the strap with the red sticker on top of the other one (Fig. Buckles for car safety belt To fasten the two buckles to the pins at the two ends of the carrycot (Fig. 8), fit each buckle to its pin by pressing it down (Fig. HOW TO REMOVE KIT TRIO CAR FROM THE CARRYCOT When you no longer wish to use the carrycot in the car, or if you wish to use it outside the car, KIT TRIO CAR can be removed as follows. Unthread the strap first from the left-hand slot by pulling it downwards and then from the right-hand one by pulling it upward (Fig. Buckles for the car seat belts Pull the red tab of the buckle outwards and push the buckle upwards (Fig. 28) HOW TO CLEAN THE PRODUCT Belt and buckles must be cleaned only by hand, using a damp cloth. Use only water; do not use either solvents or any other detergents. These instructions must be carefully kept in their special compartment, from which they can be easily retrieved. The product must be fitted exactly as described in the instructions provided. Never fit the product with a two-point safety belt. Fit the product only to car seats that are properly secured to the car chassis facing forward. Any foldable, collapsible, or revolving car seats should be properly secured. Ensure also that there are no loose objects in the car - especially at the back: in case of a knock or sudden Braking, they might otherwise hit into the passengers injuring them. [. . . ] Pillows or blankets, between the car seat, or place between the child seat and the carrycot, or between the carrycot and the child. Do not place any heavy objects on the product. Always ensure that all passengers in the car wear safety belts for their own safety and because, while travelling, they could knock against the child. Keep the plastic bags away from the child to prevent the risk of suffocation. [. . . ]