User manual JANE MATRIX LIGHT

[. . . ] You can also find them on our web page: www. In order to protect your baby adequately and to ensure their comfort and stability in the car, the following instructions must be strictly followed: Your MATRIX LIGHT safety seat can be installed in both the front seat, if it does not have an airbag, and in the back seat of your car. Either way, we advise you to install it in the back seat. If you position it in the front seat of the car, this must NOT have an AIRBAG, or the airbag must be disconnected. [. . . ] Aps Release the button or flap and move the adjustment mechanism to the nearest locking position, it should click into place. Choosing where to install the safety seat Correctly choosing where to position the safety seat in the car can reduce the risk of injury to the baby in the event of an accident. The safety seat must be installed cross-wise in the back seats. MATRIX LIGHT occupies two seats: you can choose between a side and a middle seat, so an adult can travel alongside, or completely in the middle. If you decide on middle and side seats, place the MATRIX LIGHT so that the head is as far as possible from the door. Whenever possible, install the safety seat in the back seats. It is highly advisable that someone travels alongside the baby to take care of them. Of the three back seats, the middle one is the safest. If you are travelling alone with your baby, it is a good idea to keep them in sight without being distracted while driving. You can position them in the passenger seat, providing it does NOT have an airbag or the airbag IS DISCONNECTED. Do not be distracted for any reason while driving: to take care of the baby, stop the car completely in a safe place. The MATRIX LIGHT safety seat must be installed FACING AWAY FROM THE DIRECTION OF TRAVELLING. Decide on which seat after reading the section on "Choosing where to install the safety seat". 2g - Position the safety seat on the seat of the vehicle. put the handle in the AUTO position , the position furthest forward. 2h - Pass the abdominal part of the car seat belt through the two front guides situated on the sides of the frame. 2i - The shoulder belt of the car should be passed behind the safety seat. 2j - Tighten this part of the belt and fasten the locking clip. Make sure that the seat is firmly fastened by pulling it. In the reclining position, MATRIX LIGHT must be fitted cross-wise on the back seats. Decide on which seats after reading the section on "Choosing where to install the safety seat". 2a - Fasten the two straps you have chosen, the fasteners are on the abdominal part of the belt, this area is marked in light blue in the diagrams. [. . . ] Undo the Velcro strips that are in the area of the seat belts and pull the upholstery. Wash by hand at a temperature never higher than 30° C. To refit the cover, follow the same steps in reverse order. Keep this instruction book for future reference. [. . . ]