User manual JANE MATRIX LIGHT 2

[. . . ] Either way, we advise you to install it in the back seat. If you position it in the front seat of the car, this must NOT have an AIRBAG, or the airbag must be disconnected. It is only suitable for cars fitted with three anchoring point automatic belts, approved according to Regulation ECE-16 or other equivalent rules. DO NOT use with a two anchoring point belt. [. . . ] Avoids the inconvenience of having to fasten and unfasten straps when you need to change the height of the straps. Rele the n locke 1 Prior adjustments Changing the position of the handle The carrying handle has 3 positions ( figure 1b ), each one of them has a specific function: Position 1: Hood folded. Position for installing the seat and taking it off a JANÉ chassis and for carrying. To change the position, press the double safety catch and then the lever on the handle and turn the handle to the required position. Adjusting the height of the shoulder straps For maximum protection the shoulder straps of the MATRIX LIGHT safety seat should be adjusted to just above the baby’s shoulders. Check this height with the baby in the sitting or lying down position in the safety seat. The straps can be adjusted using a tightener so that the seat adjusts to your baby during the whole stage of growth. The MATRIX LIGHT safety seat has a quick shoulder strap height adjustment system, you just have to press a button and slide the adjustment mechanism along the backrest 1a MATRIX LIGHT has 6 different heights for the shoulder straps. There are two possible ways of changing the position: 1a. 1 To change the position when lying down, pull the plastic flap and slide the adjustment mechanism. 2 To change the position when sitting down, press the button on the backrest and slide it to the required position. Reclining position, GROUP 0 In the reclining position, MATRIX LIGHT must be fitted cross-wise on the back seats. Decide on which seats after reading the section on “Choosing where to install the safety seat”. 2a - Fasten the two straps you have chosen, the fasteners are on the abdominal part of the belt, this area is marked in light blue in the diagrams. 2b - Open the fastener of the belt by turning the lock 2c - Insert the abdominal part of the belt into the fastener and close the fastener again. 2e - To take the TRANSPORTER seat out of the vehicle, open the fastener of the belt by turning the lock and take the seat belt off. If you observe that the car seat belts are not long enough, you can adjust the following parameters to improve this: - Recline the backrest of the car seat a little. - Adjust the shoulder height regulator of the car seat belts to - Move the car seat back. English 25 3 Placing the baby in the safety seat WARNING Never leave the baby on their own. Always remember to carry your baby with the safety harnesses correctly buckled. For your baby’s proper development, we advise you not to over-use the carry cot in the seated position on long journeys, letting the baby rest in the reclining position (for babies up to 10 Kg). Any alteration or addition to the device without proper authorisation from JANÉ may seriously alter the safety of the retaining system. [. . . ] Follow the instructions below: • Unfasten the safety harness clip and pass it through the slot in the upholstery. € Take off the rubber bands that go underneath the car seat belt fasteners. € And take off those that are on the base next to the handle. € Take the upholstery off the MATRIX LIGHT safety seat. [. . . ]