User manual JANE MONTECARLO R1

[. . . ] However, whenever the vehicle manufacturer states that the seats are suitable for “Universal” type car safety seats this means it is fully compatible. It is very important that you read these instructions carefully before using the MONTECARLO R1 safety seat for the first time. Make sure that everyone who is ever going to use the car seat also knows how to install it and use it properly. It is a known fact that a significant percentage of car seat users do not install them correctly. [. . . ] Check and adjust this position as the child grows. 26 Choosing where to install the safety seat Choosing the correct place to install the safety seat in the vehicle can reduce the risk of injury to the child in the event of an accident. If possible the safety seat should be installed on the back seat of the vehicle. there are two possible installations: 1. With Isofix anchors and the 3-point seat belt; follow the instructions in the “semi-universal” section below. Remember that for this safety seat the ISOfix anchors are only used to give the seat greater stability, in the event of an accident the child is restrained with the 3-point seat belt. Also bear in mind that it is “Semi-universal” and not all vehicle seats are compatible, consult the Vehicle List included in a leaflet with the instructions or go straight to our web page www. Just with the 3-point seat belt; follow the instructions in the “Universal” section. In other words, it is compatible with most vehicle seats. However, whenever the vehicle manufacturer states that the seats are suitable for “Universal” type car safety seats this means it is fully compatible. Raise or remove the vehicle headrest if it interferes with the safety seat headrest. On seats fitted with a frontal air-bag, move the seat as far back as possible. Installing your Montecarlo R1 in the vehicle 3 Semi-universal and Universal installation: Semi-universal: with ISOfix anchors and the 3-point seat belt ISOFIX The ISOfix anchors have been designed to safely and easily secure child restraint systems. Not all vehicles are fitted with these anchors, although they are now generally standard in newer models. Consult the enclosed leaflet to see the vehicle list stating in which vehicles the safety seat can be correctly installed. An updated list can be found on the JANÉ web page (www. English 27 If you are going to install your MONTECARLO R1 with the rigid anchors, follow the steps below carefully: 3a First remove the end caps, to do this, pull the anchor button. Keep the end caps in case you use the MONTECARLO R1 without ISOfix in the future. 3b Pull the anchor out pressing the red buttons on the sides (13). 3c Make sure that both anchors are open, the red signal should be displayed on the anchor button (12). Place your MONTECARLO R1 on the vehicle seat in accordance with the advice and warnings contained in the GENERAL INSTRUCTIONS. Before installing the safety seat find the ISOfix anchors on the vehicle seat. [. . . ] English 31 INFORMATION ABOUT THE GUARANTEE This article comes with a guarantee in accordance with the provisions of law 23 / 2003 of 10th July. Keep your receipt as proof of purchase, it is essential to present the receipt in the shop where you bought the product to confirm validity of the guarantee in the event of any problems. This guarantee excludes any defects or breakages caused by inappropriate use of the article or inobservance of the safety and maintenance rules listed in the instruction pages and on the care labels, as well as faults caused by wear and tear through normal use and daily handling. The label displaying the chassis number of the model should never be taken off, it contains important information. [. . . ]