User manual JANE OMAD

[. . . ] JANÉ recommends that you replace your OMAD safety seat with a new one if it has been subjected to violent stresses in an accident. Check that all the straps are in the correct position and duly adjusted to your OMAD. Make sure that none of the straps are twisted. The child must understand that he must not play with the straps or fasteners under any circumstances. [. . . ] safety device preventing incorrect installation. This prevents the OMAD carrycot from being installed in the vehicle when the backrest is reclined. This prevents the carrycot from rotating in the event of an accident. comfort and safety for the baby: High-density foam mattress. Integrated 3-point seat belts, greater fastening surface area that spreads the strain out better in the event of an accident. ventilation in the frame to improve breathability. Includes a windbreak membrane to prevent the baby from feeling cold in winter and allows breathability in summer. Shock absorbing material on the whole surface area in contact with the baby. The carrying handle has 2 positions (figure 1a), each one of them has a specific function: Position 1: Hood folded. Position for fitting and removing the carrycot from a JANÉ chassis and for carrying, as well as for use in the vehicle. To change the position, press the double safety catch and then the lever on the handle and turn the handle to the required position. Ensure that the belt has not been caught between the folding seats or doors. It is only suitable for cars fitted with three anchoring point automatic belts, approved according to Regulation ECE-16 or other equivalent rules. DO NOT use with a two anchoring point belt. 3c - Place the baby in the safety carrycot making sure that he is lying down on the base with his back completely flat. Clip the two upper ends of the clasp together. 3d - Insert them in the central lock and press until you hear a click. OMAD can be anchored on any JANÉ chassis that has the PROFIX system. 4a - To fit the safety seat on a chassis, insert the connections in the cavity of the chassis and press until you hear a click. 4b - To release your OMAD from the chassis, press the button on the handle and pull the seat upwards. Not all safety systems are exactly the same, so we advise that you check your OMAD in the car in which it is going to be fitted. It is very important not to use second-hand products, as JANÉ can only guarantee complete safety with items used by their first buyer. [. . . ] Remove the rubber band that goes underneath one of the car seat belt fasteners and undo the clasps from the other. Remove the upholstery from the edges of your OMAD carrycot. Undo the safety harness clasp and pass it through the slot in the mattress upholstery. Take the upholstery off the backrest and pass the shoulder straps through the slots. [. . . ]