User manual JANE TWONE

[. . . ] The parking device shall be engaged when placing and removing the children. Any load attached to the handle and/or on the back of the backrest and/or on the sides of the vehicle will affect the stability of the vehicle. This vehicle has been designed to be used by one or two children. Do not use it with more children at the same time. [. . . ] 2 - ADJUSTING THE ANGLE OF THE BACKREST OF THE TOP HAMMOCK In order to provide the child with maximum comfort at all times, the hammock has a reclining system. Pull the catch on the top rear part of the backrest and adjust the angle to one of the 3 positions possible. 11 Position “P” is not suitable for travelling. 2 -ADJUSTING THE ANGLE OF THE BACKREST OF THE BOTTOM HAMMOCK Use the buttons found on the sides of the hammock and adjust the angle to one of the 2 positions possible. 2 - FITTING AND REMOVING THE BOTTOM HAMMOCK The safety armrest is designed to fit into the slots on the hammock. If required you can release just one side by pressing the side buttons and the armrest will be fully articulated by the other end. 13 -13a WARNING: The child should be kept away from the mobile parts when the responsible adult is handling these. The appearance of cutting, compression and pinch points are inevitable during these operations. This hammock is designed for an older child than the one in the top hammock, therefore it is always fitted facing forwards. 10 Make sure that the hammock is securely attached to the chassis by pulling it upwards gently. To disconnect it, simultaneously pull the two catches on both sides of the hammock. 10a english 31 The pro-fix system allows the TWONE hammock to be fitted onto the chassis perfectly. Because it is reversible, the hammock can be fitted facing you when the child is very small or facing forwards as he grows. Make sure that the hammock is securely attached to the chassis by pulling it upwards gently. 8 - 8a To disconnect it, simultaneously pull the unlocking levers on both sides of the hammock upwards. - USING THE HOOD To fit the hood onto the frame of the hammock, slide it from the top down to the corresponding slots on the central part. Use the zip on the hood to join it to the frame. 14 To take the hood off, follow the same procedure in reverse order. Once the hood is fitted, its position can be adjusted by moving the spokes to suit the angle of the backrest. Insert the hood of the bottom hammock into the holes found above the side buttons. Simultaneously press the two buttons found on the bottom part of the hammock to turn it downwards. To move it upwards it is not necessary to press the button, simply pull the footrest. [. . . ] Keep your receipt as proof of purchase, it is essential to present the receipt in the shop where you bought the product to confirm validity of the guarantee in the event of any problems.   This guarantee excludes any defects or breakages caused by inappropriate use of the article or inobservance of the safety and maintenance rules listed in the instruction pages and on the care labels, as well as faults caused by wear and tear through normal use and daily handling. The label displaying the chassis number of the model should never be taken off, it contains important information. Notice: For the maximum safety and care of your new JANÉ product, it is very important that you complete the registration card found on the web page www. [. . . ]