User manual JBL BALBOA CENTER (220-240V)

[. . . ] Slight variations will not diminish your listening pleasure. All of the Balboa Series loudspeakers referred to in this guide are video-shielded MODEL: BALBOA 30 and can safely be placed near a television. MODEL: BALBOA 10 As front speakers As surround speakers Placement for surround back speakers in 6. 1/7. 1 systems, or alternate placement for side surround speakers in 5. 1 systems. MODEL: BALBOA CENTER The Balboa Center loudspeaker is designed to complement all of the Balboa Series loudspeakers. It is the ideal way to re-create the cinematic experience in your home. ® BALBOA SERIES BALBOA 10, BALBOA 30 AND BALBOA CENTER OWNER'S GUIDE English SPEAKER PLACEMENT MODELS: BALBOA 10 AND BALBOA CENTER (CONTINUED) CAUTION: Floorstanding (tower) loudspeakers have a high center of gravity and may become unstable and tip over during earthquakes, or if rocked, tipped or improperly positioned. If this is a concern, these speakers should be anchored to the wall behind them, using the same procedures and hardware customary for anchoring bookcases and wall units. [. . . ] To comply with European CE certification, these holes are blocked with plastic inserts at the point of manufacture. Use of banana-type connectors requires the removal of the inserts. Do not remove these inserts if you are using the product in an area covered by the European CE certification. MODELS: BALBOA 10 AND BALBOA 30 RIGHT LEFT ­ + ­ + ­+ RIGHT ­ + LEFT Receiver's Speaker Outputs MODEL: BALBOA CENTER ­ ­ + + CENTER Receiver Speaker Outputs TROUBLESHOOTING If there is no sound from any of the speakers: · Check that receiver/amplifier is on and that a source is playing. · Review proper operation of your receiver/amplifier. If there is no sound coming from one speaker: · Check the "Balance" control on your receiver/amplifier. · Check all wires and connections between receiver/ amplifier and speakers. · Make sure no wires are touching other wires or terminals and creating a short circuit. · Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured. · In Dolby* Digital or DTS® modes, make sure that the receiver/processor is configured so that the speaker in question is enabled. · Turn off all electronics and switch the speaker in question with one of the other speakers that is working correctly. Turn everything back on, and determine whether the problem has followed the speaker, or has remained in the same channel. If the problem is in the same channel, the source of the problem is most likely with your receiver or amplifier, and you should consult the owner's manual for that product for further information. If the problem has followed the speaker, consult your dealer for further assistance or, if that is not possible, visit www. jbl. com for further information. If the system plays at low volumes but shuts off as volume is increased: · Check all wires and connections between receiver/ amplifier and speakers. · Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured. · If more than one pair of main speakers is being used, check the minimum impedance requirements of your receiver/ amplifier. If there is no (or low) bass output: · Make sure the polarities (+ and ­) of the left and right "Speaker Inputs" are connected properly. · If your system includes a powered subwoofer, make sure it is connected correctly, plugged into an active AC outlet and turned on. [. . . ] Part No. 406-000-05179 * Trademarks of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc. ** The maximum recommended amplifier power rating will ensure proper system headroom to allow for occasional peaks. We do not recommend sustained operation at these maximum power levels. [. . . ]