User manual JBL CS 460 (220-240V)

[. . . ] ® CINEMA SOUND SPEAKERS CS460 (230V) OWNER'S GUIDE English READ FIRST!Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. [. . . ] Placement will depend upon your room (for example, whether or not your room permits placement of the subwoofer near either satellite) and the amount and quality of bass required. 4 WALL-MOUNTING THE SATELLITES AND CENTER CHANNEL The CS460 satellites and center channel are designed to be mounted on the wall. There is a fixed-mount wall bracket and an adjustable wall bracket provided for each satellite and the center channel. Each speaker bracket will require up to four 1-1/2" #10 wood screws; each screw should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2" #10 screw. NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers. Mark the positions on the wall where you would like to place the mounting screws. Attach the bracket to the wall using two screws (not included). Remove the rubber ring on the bottom of the satellite and sit the satellite or center channel speaker onto the back bracket. Attach 1/4-20" screw into insert on bottom of speaker and tighten. Unscrew round collar (C) from bracket (A). A B C Adjustable Wall Bracket Step 1. Remove cap over threaded insert on rear of speaker. Mark the positions on the wall where you would like to place the mounting screws. Place bracket against the wall and fasten four 1-1/2" #10 wood screws through the bracket's screw holes into the wall. If a wall stud is not available, use an appropriate anchor. . Screw the ball and shaft assembly (B) to the 1/4"-20 insert on the back of the satellite or the center channel (do not use the bottom insert on either speaker). Back out 1/2 of a turn and tighten the nut against the speaker. If the ball and shaft assembly is not backed out before tightening the nut, performing Step 8 below may dislodge the threaded insert in the speaker housing and permanently damage the speaker. Step 6. Drop round collar (C) over ball and shaft assembly (B) that is mounted to the speaker with the finished side of the collar facing the rear of the speaker. Carefully push the ball straight into the socket mounted on the wall, angle the speaker as desired and tighten the collar using the enclosed metal bar. Metal bar Figure 3. Bracket on wall. 5 English CENTER AND SATELLITE SPEAKER CONNECTIONS Turn Off All Power After placing the speakers, you are ready to connect your system. Use high-quality speaker wire to make your connections. #18-gauge speaker wire with polarity coding is included. [. . . ] During periods of normal use, the Power Switch can be left on. You may turn off the Power Switch for extended periods of nonoperation, e. g. , when you are away on vacation. Adjust Level Turn the Subwoofer-Level Control up about halfway. If no sound emanates from the subwoofer, check the AC-line cord and input cables. [. . . ]