User manual JBL GTO505C

[. . . ] GTO SERIES GTO Component Systems Owner's Manual GTO505C GTO605C Installation Warnings and Tips JBL GTO Series Component Systems About These Instructions Installation of automotive stereo components can require extensive experience with a variety of mechanical and electrical procedures. Although these instructions explain how to install a GTO Series Component System in a general sense, they do not show the exact installation methods for your particular vehicle. If you feel you do not have the experience, do not attempt the installation yourself, but instead ask your authorized JBL car audio dealer about professional installation options. [. . . ] Do not use any cleaners or solvents on the grilles or the speaker cones. Installation Tips · Always wear protective eyewear when using any tools. · Turn off all audio components and other electrical devices before you start. Disconnect the negative (­) lead from your vehicle's battery. · Keep speakers in their package until final installation. When moving a speaker, always rest it with the cone or dome facing up. · Check clearances on both sides of a planned mounting surface before drilling any holes or installing any screws. Remember that the screws can extend behind the surface. · At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines, vacuum lines and electrical wiring. Use extreme caution when cutting or drilling in and around these areas. · Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl to keep material from snagging in a drill bit or saw. · For door installations, check the clearance with the windows throughout the range of the window's travel, and verify that a mounted speaker will not interfere with the window crank or powerwindow mechanism. · If mounting speakers elsewhere, check for clearance around reardeck torsion bars, glove box or other structural elements. · Do not mount speakers where they will get wet. 02 Installation and Connections JBL GTO Series Component Systems Figure 1. Mounting the GTO505C woofer with the grille. Mounting the GTO605C woofer in a standard speaker location. [. . . ] Mounting the tweeter using the surface-mounting kit. blk blk red 1 2 ­ + red 1 ­ + Large Lug = 2 Small Lug = 03 Specifications JBL GTO Series Component Systems Type System Frequency Response Woofer Speaker Impedance Power Handling Sensitivity (2. 83V, 1m) Mounting Depth Cut-out Diameter Tweeter Speaker Impedance Power Handling Sensitivity (2. 83V, 1 m) GTO505C 5-1/4" 2-way component 70Hz ­ 21kHz 4 ohms 75W RMS, 225W peak 92dB 2 - 3 /16" (56mm) 4- 5 / 8" (118mm) 4 ohms 50W RMS, 150W peak 91dB GTO605C 6 -1/ 2" 2-way component 55Hz ­ 21kHz 4 ohms 90W RMS, 270W peak 92dB 2 -1/16" (53mm) 5 -1/16" (129mm) 4 ohms 50W RMS, 150W peak 91dB Declaration of Conformity JBL Consumer Products · 250 Crossways Park Drive, Woodbury, NY 11797 USA 1-800-336-4JBL (4525) www. jbl. com ©2001 JBL, Incorporated · JBL is a registered trademark of JBL, Incorporated Made in USA Printed in USA 3/01 Part No. GTOCOMPSYSOM3/01 We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir FRANCE declare in own responsibility, that the products described in this owner's manual are in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1992 Lutz Uphoff Harman Consumer International Chateau-du-Loir, France. [. . . ]