User manual JBL GTO6425

[. . . ] GTO SERIES Multi-Element Speakers Owner's Manual GTO325 GTO425 GTO525 GTO625 GTO635 GTO6425 GTO7525 GTO925 GTO935 Installation Warnings and Tips JBL GTO Series Multi-Element Speakers About These Instructions Installation of automotive stereo components can require extensive experience with a variety of mechanical and electrical procedures. Although these instructions explain how to install GTO Series multi-element speakers in a general sense, they do not show the exact installation methods for your particular vehicle. [. . . ] To insure correct polarity connections, each speaker is also equipped with keyed terminals (see Figure 4 on page 3). General Care The loudspeaker grilles may be cleaned with a damp cloth. Do not use any cleaners or solvents on the grilles or the speaker cones. Installation Tips · Always wear protective eyewear when using any tools. · Turn off all audio components and other electrical devices before you start. Disconnect the negative (­) lead from your vehicle's battery. · Keep speakers in their package until final installation. When moving a speaker, always rest it with the cone or dome facing up. · Check clearances on both sides of a planned mounting surface before drilling any holes or installing any screws. Remember that the screws can extend behind the surface. · At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines, vacuum lines and electrical wiring. Use extreme caution when cutting or drilling in and around these areas. · Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl to keep material from snagging in a drill bit or saw. · For door installations, check the clearance with the windows throughout the range of the window's travel, and verify that a mounted speaker will not interfere with the window crank or powerwindow mechanism. [. . . ] The GTO's keyed terminals aid in making correct polarity connections. Large Lug = Small Lug = ROTATE AND AIM TWEETER SO IT FACES THE LISTENER USING THE OMNIPIVOTTM FEATURE ON THE GTO525, GTO625, GTO6525, GTO7525 AND GTO925. Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir FRANCE declare in own responsibility, that the products described in this owner's manual are in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1992 Lutz Uphoff Harman Consumer International Chateau-du-Loir, France. 3/01 03 Specifications JBL GTO Series Multi-Element Speakers Type Speaker Impedance Power Handling Sensitivity (2. 83V, 1m) Frequency Response Mounting Depth Cut-out Diameter GTO325 3-1/ 2" 2-way 4 ohms 25W RMS, 75W peak 92dB 90Hz ­ 21kHz 1-3 / 8" (35mm) 3-1/4" (83mm) GTO425 4" 2-way 4 ohms 35W RMS, 100W peak 92dB 90Hz ­ 21kHz 2-1/ 8" (54mm) 3- 9 /16" (91mm) GTO525 5-1/ 4" 2-way 4 ohms 45W RMS, 135W peak 92dB 70Hz ­ 21kHz 2-3 / 16" (56mm) 4-5 / 8" (118mm) GTO625 6-1/ 2" 2-way 4 ohms 60W RMS, 180W peak 92dB 55Hz ­ 21kHz 2-1/ 16" (53mm) 5-1/ 16" (129mm) Type Speaker Impedance Power Handling Sensitivity (2. 83V, 1m) Frequency Response Mounting Depth Cut-out Diameter GTO635 6-1/ 2" 3-way 4 ohms 60W RMS, 180W peak 92dB 55Hz ­ 21kHz 2-1/ 16" (53mm) 5-1/ 16" (129mm) GTO6425 4" x 6" 2-way 4 ohms 40W RMS, 120W peak 91dB 75Hz ­ 21kHz 1-5 / 8" (42mm) 5-11/16" x 3-1/4" (145mm x 83mm) GTO7525 5" x 7" 2-way 4 ohms 60W RMS, 180W peak 92dB 50Hz ­ 21kHz 2-3 / 16" (56mm) 7-3 / 16" x 5" (183mm x 127mm) GTO925 6" x 9" 2-way 4 ohms 100W RMS, 300W peak 92dB 50Hz ­ 21kHz 2-7/ 8" (74mm) 8-3/4" x 5-15/16" (223mm x 151mm) 04 Type Speaker Impedance Power Handling: Sensitivity (2. 83 V, 1m) Frequency Response Mounting Depth Cut-out Diameter GTO935 6" x 9" 3-way 4 ohms 100W RMS, 300W peak 92dB 50Hz ­ 21kHz 2-7/ 8" (74mm) 8-3/4" x 5-15/16" (223mm x 151mm) JBL Consumer Products · 250 Crossways Park Drive, Woodbury, NY 11797 USA 1-800-336-4JBL (4525) www. jbl. com ©2001 JBL, Incorporated · JBL is a registered trademark of JBL, Incorporated Made in USA Printed in USA 3/01 Part No. [. . . ]