User manual JBL L101

[. . . ] Refer all servicing to qualified service personnel. 8. The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products that produce heat. If placed near an amplifier, check with the manufacturer for applicability. Refer servicing to qualified service personnel under the following conditions: a. [. . . ] The product does not operate normally when following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation; or c. The product has been dropped, or the enclosure damaged; or d. The product does not appear to operate normally or exhibits a marked change in performance. Do not use attachments not recommended by the product manufacturer, as they may cause hazards. When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Château-du-Loir France declare in own responsibility, that the product described in this owner's manual is in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1992 Luc Emmanuel Godard JBL, Harman Consumer International France, 09/01 THANK YOU FOR CHOOSING JBL For more than 50 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office. We're confident that the JBL system you have chosen will provide every note of enjoment that you expected ­ and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL. JBL Consumer Products 2 INCLUDED Two satellites for Left/Right front or surrounds. Wall-mount brackets. SPEAKER PLACEMENT Front Speakers Surround Speakers 150-180 cm The front speakers should be placed the same distance from each other as they are from the listening position. They should be placed at about the same height from the floor as the listeners' ears will be, or they may be angled toward the listeners. Make sure none of the speaker wires are frayed, cut or punctured. · If your receiver/processor is set in Dolby Pro Logic mode, make sure the center speaker is not in phantom mode. · If your receiver/processor is set in Dolby Digital or DTS® mode, make sure the receiver/processor is configured so that the center speaker is enabled. If the system plays at low volumes but shuts off as volume is increased: · Check all wires and connections between receiver/ amplifier and speakers. Make sure none of the speaker wires are frayed, cut or punctured. · If more than one pair of main speakers is being used, check the minimum impedance requirements of your receiver/amplifier. If there is low (or no) bass output: · Make sure the connections to the left and right "Speaker Inputs" have the correct polarity (+ and ­). · If a powered subwoofer is used, make sure that the subwoofer is plugged in and turned on. · In Dolby Digital or DTS® modes, make sure your receiver/processor is configured so that the subwoofer and LFE output are enabled. If there is no sound from the surround speakers: · Check all wires and connections between receiver/ amplifier and speakers. Make sure none of the speaker wires are frayed, cut or punctured. [. . . ] Make sure none of the speaker wires are frayed, cut or punctured. · Review proper operation of your receiver/amplifier and its surround-sound features. · Make sure the movie or TV show you are watching is recorded in a surroundsound mode. If it is not, check to see if your receiver/ amplifier has other surround modes you may use. [. . . ]