User manual JBL N26 II

[. . . ] Slight variations will not diminish your listening pleasure. All of the Northridge Series loudspeakers referred to in this guide are video-shielded and can safely be placed near a television. X+ MODELS: N38II, ND310II 0+ Y2 0 M HZ 4" 8" X+ MODELS: N26II, N28II 0+ As Front Speakers 2 Y 0 M HZ As Surround Speakers 5 ­ 6 ft. X + 0 + Y 2 0 M HZ N26II, N28II, N38II, END310II OWN R'S GUIDE PRODUCT LINE: NORTHRIDGETM SERIES PRO SOUND COMES HOMETM SPEAKER CONNECTIONS CONNECTION TIPS ­ RIGHT LEFT + ­ + ­+ Speakers and electronics terminals have corresponding (+) and (­) terminals. It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (­) on the speaker to (­) on the amplifier. [. . . ] Customer is responsible for proper installation and proper selection of hardware. TROUBLESHOOTING If there is no sound from any of the speakers: · Check that receiver/ amplifier is on and that a source is playing. · Review proper operation of your receiver/amplifier. If there is no sound coming from one speaker: · Check the "Balance" control on your receiver/ amplifier. · Check all wires and connections between receiver/amplifier and speakers. · Make sure no wires are touching other wires or terminals and creating a short circuit. · Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured. · In Dolby* Digital or DTS® mode, make sure that the receiver/processor is configured so that the speaker in question is enabled. · Turn off all electronics and switch the speaker in question with one of the other speakers that is working correctly. Turn everything back on, and determine whether the problem is in the same place, i. e. , the speaker that was working previously now has no sound and the speaker that was not working now sounds fine; or whether it has moved, i. e. , the speaker that was not working still has no sound and the speaker that was working is still fine. If the problem is in the same place, the source of the problem is most likely with your receiver or amplifier, and you should consult the owner's manual for that product for further information. If the problem has followed the speaker, consult your dealer for further assistance or, if that is not possible, visit our Web site at www. jbl. com for further information. If the system plays at low volumes but shuts off as volume is increased: · Check all wires and connections between receiver/amplifier and speakers. · Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured. · If more than one pair of main speakers is being used, check the minimum impedance requirements of your receiver/amplifier. [. . . ] 7/01 S P E C I F I C AT I O N S N26II Description: 2-Way 6" bookshelf Maximum Recommended Amplifier Power:** 125W Nominal Impedance: 8 Ohms Sensitivity (2. 83V/1m): 88dB Frequency Response (­3dB): 55Hz ­ 20kHz Crossover Frequency(ies): 3000Hz High-Frequency 3/4" Titanium-laminate Transducer: dome, shielded Midrange Transducer: NA Low-Frequency Transducer: 6" PolyPlas, TM shielded N28II 2-Way 8" bookshelf N38II 3-Way 8" floorstanding ND310II 3-Way dual 10" floorstanding 150W 8 Ohms 90dB 50Hz ­ 20kHz 4000Hz 3/4" Titanium-laminate dome, shielded NA 8" PolyPlas, TM shielded 175W 8 Ohms 90dB 45Hz ­ 20kHz 1000, 5000Hz 3/4" Titanium-laminate dome, shielded 4" PolyPlas, TM shielded 8" PolyPlas, TM shielded Low Diffraction, IsoPowerTM FreeFlowTM flared Straight-Line Signal PathTM (SSP) 5-Way binding posts 34" x 10-1/2" x 11-7/8" 864mm x 267mm x 302mm 35 lb, 15. 9kgs 250W 8 Ohms 91dB 37Hz ­ 20kHz 1000, 5000Hz 3/4" Titanium-laminate dome, shielded 4" PolyPlas, TM shielded Dual 10" PolyPlas, TM shielded Low Diffraction, IsoPowerTM FreeFlowTM flared Straight-Line Signal PathTM (SSP) 5-Way binding posts 42" x 14-1/2" x 12" 1067mm x 368mm x 305mm 55 lb, 25kgs Baffle: Low Diffraction, IsoPowerTM Low Diffraction, IsoPowerTM Port: FreeFlowTM flared Network: Straight-Line Signal PathTM (SSP) Terminals: 5-Way binding posts Dimensions 17" x 9" x 10" (H x W x D): 432mm x 229mm x 254mm Weight: 18 lb, 8. 2kgs FreeFlowTM flared Straight-Line Signal PathTM (SSP) 5-Way binding posts 19-1/2" x 10-1/2" x 11-1/4" 495mm x 267mm x 286mm 22. 5 lb, 10. 2kgs **The maximum recommended amplifier power rating will ensure proper system headroom to allow for occasional peaks. We do not recommend sustained operation at these maximum power levels. All features and specifications are subject to change without notice. [. . . ]