User manual JBL ON STAGE II REMOTE

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and then on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment to a different outlet so that the equipment and receiver are on different branch circuits. [. . . ] Although the speakers are magnetically shielded, keep magnetic storage media (disks and tapes) at least four inches from the speaker system in order to avoid data loss. WARNING: To reduce the risk of fire or electric shock, do not expose this speaker system to rain or moisture. Volume Up Music Browsing Before proceeding, make sure the iPod® is docked into the JBL on stageTM* II and the remote Hold Switch is in a position so that the orange dot is not visible. Turn iPod® On: Turn iPod® Off: Play a Track: Pause a Track: Skip to Next Track: Skip to Previous Track: Fast Advance Track: Fast Reverse Track: Increase Volume: Decrease Volume: Lock Remote Buttons: Press any button on the remote control to wake the iPod®. Note: If the iPod® is at the Main Menu, button while a song is playing. Pressing Play/Pause will cause the iPod® to start playing all of its music. Photo Browsing (iPod® in photo browsing mode) The JBL on stageTM* II remote control can be used to browse images on your iPod® Photo player. To do so, the remote control needs to be in the Photo Mode by following two steps listed below: 1. The remote is ready to browse photos forward or backward by pressing the Volume Up and Volume Down buttons, respectively. To exit Photo mode, slide the Hold switch from Active to Hold, then back to Active. If you have any questions, or need further assistance, please visit www. " If more than one JBL on stageTM* II Remote control is within range of the speaker unit, multiple remotes would be able to control the speaker unit. If this is not desirable, the speaker unit must be paired with a unique remote. pairing allows only one remote to control the speaker unit. To Turn Pairing On Press the Pairing switch on the bottom of the JBL on stageTM* II unit by inserting a paper clip or similar device. Then press any button on the Remote within 5 seconds to associate that particular remote with the unit. [. . . ] Wait for 30 recognize the remote's commands seconds. Dock the iPod® again and turn the JBL on stageTM* II on. Battery Replacement The JBL on stageTM* II remote's battery should last a year under normal usage. [. . . ]