User manual JBL SCS 178 SAT. PAIR

[. . . ] Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. The product should be mounted on a wall or ceiling only when and as recommended by the manufacturer. Important Safety Precautions! 12. Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. [. . . ] The surround speakers should not call attention to themselves. Experiment with their placement until you hear a diffuse, ambient sound accompanying the mainprogram material heard in the front speakers. SCS SATPair 178 speakers are perfect for bringing music to additional rooms in your home. If your receiver or amplifier is equipped with A/B speaker switching, simply connect the pair of speakers to the unused pair of speaker terminals on your receiver, following the directions in the Speaker Connections section. If you plan on playing both pairs of speakers simultaneously, check with the manufacturer of your receiver or amplifier to find out whether that use is recommended. 3 MOUNTING OPTIONS Satellites and Surrounds On shelves. On the wall. Wall brackets are included. On optional stands. Wall-Mounting The customer is responsible for proper selection and use of mounting hardware, available through hardware stores, to properly and safely wall-mount the speakers. SPEAKER CONNECTIONS Connection Tips It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (­) on the speaker to (­) on the amplifier. Wiring "out of phase" results in thin sound, weak bass and a poor stereo image. With the advent of multichannel surround-sound systems, connecting all of the speakers in your system with the correct polarity remains equally important in order to preserve the proper ambience and directionality of the program material. Stereo If you are using the JBL SCS SATPair178 in a stereo system, connect them to the Left and Right speaker outputs of your amplifier/receiver. Surround If you are using the JBL SCS SATPair178 as front or rear speakers in a surround system, connect them to the appropriate front or rear Left and Right outputs according to the instructions included with your surround amplifier/receiver. Separate and strip the ends of the speaker wire as shown. Speakers and electronics terminals have corresponding (+) and (­) terminals. Most manufacturers of speakers and electronics, including JBL, use red to denote the (+) terminal and black for the (­) terminal. 4 TROUBLESHOOTING If there is no sound from any of the speakers: · Check that receiver/amplifier is on and a source is playing. · Check all wires and connections between receiver/ amplifier and speakers. Make sure none of the speaker wires are frayed, cut or punctured. · Review proper operation of your receiver/amplifier. If there is no sound coming from one speaker: · Check the "Balance" control on your receiver/amplifier. · Check all wires and connections between receiver/ amplifier and speakers. Make sure none of the speaker wires are frayed, cut or punctured. [. . . ] · Review the operation of your DVD player and the jacket of your DVD to make sure that the DVD features the desired Dolby Digital or DTS® mode, and that you have properly selected that mode using both the DVD player's menu and the DVD disc's menu. 5 S P E C I F I C AT I O N S SCS178 Satellite Frequency Response (-6dB): Sensitivity (2. 83V/1m): Nominal Impedance: Recommended Amplifier Power Drive Units: Dimensions (H x W x D): Weight: 90Hz ­ 22kHz 86dB 4 Ohms 25 ­ 100 Watts RMS per Channel 12mm Polyamide/Titanium Laminate Video-shielded HF 100mm Paper Cone Video-shielded Mid/Bass 235mm x 140mm x 179mm (9. 3" x 5. 5" x 7") 2. 8kg (6. 2lb) Refinements may be made on occasion to existing products without notice, but will always meet or exceed original specifications unless otherwise stated. Simply Cinema is a registered trademark of JBL, Incorporated. * Dolby and Pro Logic are trademarks of Dolby Laboratories. [. . . ]