User manual JBSYSTEMS LIGHT CD 570 V1.1

[. . . ] ⷠTake care to minimize shocks and vibrations during transport. ⷠWhen installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. ⷠTo avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. [. . . ] Also with the unit in pause mode (Play/Pause LED blinks) the search and/or jog wheel is used to set a different start point. By pressing "PLAY/PAUSE" button then "CUE", you can confirm this new cue point. The CUE LED will light up since the cue button is pressed until the CD has returned to the position at which play was started. PLAY/PAUSE button: every time you press the PLAY/PAUSE button the CD player changes from play to pause or from pause to play. PITCH BEND buttons (+/-16%): The speed rises while the "+ button" is pressed and return to the original pitch when the button is released. These buttons can be used to synchronize the beats of 2 tracks. PITCH button: This button is used to turn the Pitch function on and off. If you want to change the speed adjustment range (+/- 8%, +/- 12%, +/- 16%), press and hold PITCH button then press the PITCH BEND+ to select. The speed can be changed up to +/-16% by moving the sliding fader. The speed will not change if the PITCH LED is off. OPEN/CLOSE button: press this button to open and close the disc tray in the front of the main unit. This button is disabled during playback. TIME Button: The TIME button switches between elapsed playing time, remaining time in a selection and total remaining time of the disc. SGL/CTN Button: with this button you can choose between "single track mode" and "continuous play". ⷠContinuous play: the complete CD will be played without interruption. (mostly used in pubs) · Single track: player stops at the end of each track and waits at the beginning of the next track. The player will wait at the first music note of each track. After programming the tracks will be played in the order you programmed. You can also use the relay function to make a preprogrammed sequence on the 2 decks. Follow the steps below for programming: · Press the PROGRAM button once, the led next to it turns on and the display shows "-- P-01 00". ⷠChoose the first track in your sequence and press the PROGRAM button. The first track is programmed, the display shows "-- P-02 01" · Choose the second track in your sequence and press the PROGRAM button. [. . . ] ⷠTo stop the relay function, press the PROGRAM and SGL buttons again until the track information stops flashing. ⷠSTORING A CUE POINT: Put the player in pause and use the jog/shuttle wheel to search the exact location for the cue point. Once this location is found, press the PLAY/PAUSE button to set the new cue point. (the cue led flashes 2 times to indicate that the new cue point is set and the track starts playing from this new cue point) Once the cue point is programmed, just press the CUE button to recall it. [. . . ]